Simple fixes for the four most common refrigerator problems: an ice-maker breakdown, water leaking onto the floor, a cooling failure and too much noise. Chances are, you can solve the problem yourself, save some money and avoid the expense and inconvenience of a service appointment. The following article will walk you through the simplest solutions to the most common fridge malfunctions. Learn how to repair a refrigerator here.
Often on the bottom of people's to-do list is home maintenance chores, such as landscaping, window and gutter cleaning, power washing the siding and hard-scape, etc. However, these maintenance chores pay for themselves over time. Often, injury could occur when operating heavy machinery or when climbing on ladders or roofs around your home, so if an individual is not in the proper physical condition to accomplish these chores, then they should consult a professional. Lack of maintenance will cost more due to higher costs associated with repairs or replacements to be made later. It requires discipline and learning aptitude to repair and maintain the home in good condition, but it is a satisfying experience to perform even seemingly minor repairs.
Check for cracked housings on plastic roof vents and broken seams on metal ones. You might be tempted to throw caulk at the problem, but that solution won’t last long. There’s really no fix other than replacing the damaged vents. Also look for pulled or missing nails at the base’s bottom edge. Replace them with rubber-washered screws. In most cases, you can remove nails under the shingles on both sides of the vent to pull it free. There will be nails across the top of the vent too. Usually you can also work those loose without removing shingles. Screw the bottom in place with rubber-washered screws. Squeeze out a bead of caulk beneath the shingles on both sides of the vent to hold the shingles down and to add a water barrier. That’s much easier than renailing the shingles.
How to DIY it: Gently tug the loose part of the carpet to find the point where it’s still attached. Snip 
it off as close to the backing as possible and save it. Use painter’s tape to surround the repair area. Squeeze 
a heavy bead of carpet seam sealer (about $6 at home centers) into the run. Then fill in the hole with the saved fiber, using a screwdriver to press it into the sealer bit by bit until the area looks like the surrounding 
carpet (below).
An estimate was that in 2003, the market for home-maintenance and repair spending was up 14% from 2001 to 2003.[12] Another estimate was that the market in the United States was $126 billion and was increasing by about 4% annually.[10] American homes are aging; one estimate was that in 2007, more than half of all homes are older than 25 years.[12] And, as populations worldwide tend to become older, on average, and since increasingly elderly people will be less inclined and able to maintain their homes, it is likely that demand for handyman services will grow.[original research?][citation needed]
Sussex County Habitat for Humanity offers a Home Repair Program that performs repair services to help low-income homeowners impacted by age, disability and family circumstances reclaim their homes with pride and dignity. Volunteer teams work to improve the condition of homes by painting, landscaping, and performing minor repairs at minimal costs to homeowners who would otherwise be unable to complete home repairs on their own.  In addition, SCHFH now offers home repair and renovation services on a larger scale that aim to alleviate critical health, life and safely issues.  Able-bodied homeowners are asked to work alongside the volunteers in a cooperative effort.
With Grandma’s handymen in Aurora, Parker, Highlands Ranch and Denver, handyman help is just a phone call away! Our Denver handyman staff specializes in home maintenance and repair, and is experienced in a variety of trades including plumbing, painting, drywall, electrical, and carpentry. Click here for a list of our handyman services in Aurora, Denver, Parker, Highlands Ranch, Lone Tree, Centennial, Littleton, Lakewood, and Englewood.
Instead of forking over $5,000-10,000 to replace all of your old windows with brand new ones, consider repairing old windows yourself. With a few hundred dollars in supplies (sand paper, paint, window glaze, etc.), you’ll be prepared to reglaze every window in your house. Though it can be a tad time consuming, you can prioritize the project by room, removing windows one by one to paint, reglaze, and, if necessary, replace any cracked glass. Get started glazing your windows here.
This is a fun one. Composite wood paneling may have been all the rage in the 60s and 70s, but unless it’s still in perfect condition and painted white, it’s probably an eyesore. Popping off this decorative paneling can take minutes, and is seriously satisfying. Just be ready: you never know what condition the wall is in underneath. Be prepared to do a little plaster repair and, of course, repaint. Click here to learn how to prepare a wall for painting.

Check for cracked housings on plastic roof vents and broken seams on metal ones. You might be tempted to throw caulk at the problem, but that solution won’t last long. There’s really no fix other than replacing the damaged vents. Also look for pulled or missing nails at the base’s bottom edge. Replace them with rubber-washered screws. In most cases, you can remove nails under the shingles on both sides of the vent to pull it free. There will be nails across the top of the vent too. Usually you can also work those loose without removing shingles. Screw the bottom in place with rubber-washered screws. Squeeze out a bead of caulk beneath the shingles on both sides of the vent to hold the shingles down and to add a water barrier. That’s much easier than renailing the shingles.
If a screw turns but doesn’t tighten, the screw hole is stripped. Here’s a quick remedy: Remove the screw and hardware. Dip toothpicks in glue, jam as many as you can into the hole and break them off. You don’t have to wait for the glue to dry or drill new screw holes; just go ahead and reinstall the hardware by driving screws right into the toothpicks.
Many people can do common household repairs. There are resources on the Internet, as well as do-it-yourself guide books,[8] with instructions about how to complete a wide range of projects. Sometimes the fix-it skill is seen as genetic, and people lacking such skills are said to "lack the handy-man gene".[9] One trend is that fewer homeowners are inclined to do fix-up jobs, perhaps because of time constraints, perhaps because of lack of interest; one reporter commented "my family's fix-it gene petered out before it reached my generation."[10]
There’s nothing worse than starting a sink or toilet repair only to find that the shutoff valve won’t shut off. Some shutoff valves are easy to replace. For those that aren’t, turn off the main water valve, remove the packing nut, and then unscrew the stem and take it to the hardware store to find a replacement washer. Clean any grit out of the valve body and pop on the new washer. The valve will work like new.

Comment: I need to have two smoke detectors installed, One is in the master bedroom (vaulted ceiling) and one in the basement. I need 4 lights installed in the kitchen (vaulted ceiling). I need the battery replaced in the smoke detector in the living room (vaulted ceiling). Lastly, I would like the light bulbs replaced in 4 ceiling fans. They are in the florida room, living room (vaulted ceiling), master bedroom (vaulted ceiling), and second bedroom.

When a home is sold, inspections are performed that may reveal environmental hazards such as radon gas in the basement or water supply or friable asbestos materials (both of which can cause lung cancer), peeling or disturbed lead paint (a risk to children and pregnant women), in-ground heating oil tanks that may contaminate ground water, or mold that can cause problems for those with asthma or allergies. Typically the buyer or mortgage lender will require these conditions to be repaired before allowing the purchase to close. An entire industry of environmental remediation contractors has developed to help home owners resolve these types of problems.
A garbage disposal is a bit scary when it’s turned on and the blades are noisily chopping up kitchen waste. But, if your disposal gets stinky, fear not. It’s easy to clean out the gunk and get rid of the smell. If the splash guard needs replacing, you can do that in 20 minutes! If you need to replace the entire disposal you can replace it yourself.
How to DIY it: A simple cleaning often solves the problem. Start by pulling out the lower dish rack. 
Remove the spray arm and use a thin piece of wire to clean out the holes where water sprays through. Scoop or vacuum out any leftover food 
particles from the filter area, then 
remove the filter screen (above), if possible, and give it a good rinse.
How to DIY it: Turn it off by opening the disconnect box (typically located on the outside wall near the unit) and pulling out the disconnect block inside (above). Now take a good look at the unit. If the vents are caked with fuzz from dandelions or cottonwood trees, vacuum the vents. Then rinse the unit with a hose using moderate pressure (the flimsy fins might bend under strong pressure). As you spray, peer down into the unit. You should see water streaming through. If not, the fins are still clogged, so keep rinsing.
For most people, the home is the biggest investment. Naturally, you want to protect that investment. Rather than waiting for what would have been a small inexpensive repair to grow into a much larger, more costly expense, you need to take preventive maintenance steps. If it has been a while since your home has been assessed, now is the time to have it checked out. Learn how Home Assessments can boost your Kansas City area home’s value.
José was quick to respond to my request for an estimate to install a new back door. He came over and sized it up, sent me a fair priced quote the next day, and was back with workers soon after I accepted the quote and immediately started working. I'm extremely satisfied with the work that was performed--and the door needed to be framed and set inside the metal frames for the house, which is a little more complex than a regular door installation. I will definitely hire Jose and Jireh Contractor again!

Upholstery shops charge almost $200 to fix tears in your seats. You can do it yourself in a few hours with a vinyl and leather repair kit (less than $20) from any auto parts store. You’ll have to practice a bit to get the right color mix and it might not be a perfect match when you’re done, but it’s a heck of a lot better than driving around with torn seats. Start by gluing reinforcing fabric onto the underside of the torn vinyl or leather. Then mix the heat-set filler to match your fabric color and apply it to the tear. Next, find a textured mat that most closely resembles the texture of your vinyl or leather and place it onto the liquid filler. Heat the patching tool with a clothes iron and press it onto the textured mat. Remove the patching tool, but leave the textured mat in place until the patch cools. Then peel it off. Get the full story on repairing leather here.
You're also less likely to be overcharged if your hire a handyman. Unlike a general contractor or specialist who is more likely to price a job based on the estimated amount of time it will take to complete, you only have to pay a handyman for the hours he works, unless you agree on a flat rate. Handymen can keep their rates low because they don't have to pay additional workers, so they have lower overhead costs than contractors or large companies.

We pride ourselves on offering some of the most versatile home repair services in the area. Our crews are skilled enough to fix or improve almost anything in your house, outside and inside. Considering our services include roofs and gutters, floors and walls, and woodwork too, we can honestly say that we fix up your house from top to bottom. Each aspect is completely customized to your tastes, because we want you to enjoy every single part of your living space.
In 2009, there were national handyman service firms which handle such nationwide tasks as public relations, marketing, advertising, and signage, but sell specific territories to franchise owners. A franchise contract typically gives a franchise owner the exclusive right to take service calls within a given geographical area. The websites of these firms put possible customers in touch with local owners, which have handymen and trucks. Customers call the local numbers. Typically these firms charge around $100/hour, although fees vary by locality and time of year. In many parts of the world, there are professional handyman firms that do small home or commercial projects which claim possible advantages such as having workers who are insured and licensed. Their branch offices schedule service appointments for full-time and part-time handymen to visit and make repairs, and sometimes coordinate with sub-contractors.
While you’re at it: Any appliance that uses water has a shutoff valve. But when valves go untouched for years, mineral deposits can make them impossible to close. Before that happens, locate the valves for your washer, ice maker, water heater, etc., and turn the handle (clockwise, about a quarter turn) every year or so (more often if your water is very hard), and then turn it back. Here are some ten-minute maintenance tasks you didn’t know you needed.
Periodic maintenance also falls under the general class of home repairs. These are inspections, adjustments, cleaning, or replacements that should be done regularly to ensure proper functioning of all the systems in a house, and to avoid costly emergencies. Examples include annual testing and adjustment of alarm systems, central heating or cooling systems (electrodes, thermocouples, and fuel filters), replacement of water treatment components or air-handling filters, purging of heating radiators and water tanks, defrosting a freezer, vacuum refrigerator coils, refilling dry floor-drain traps with water, cleaning out rain gutters, down spouts and drains, touching up worn house paint and weather seals, and cleaning accumulated creosote out of chimney flues, which may be best left to a chimney sweep.

An estimate was that in 2003, the market for home-maintenance and repair spending was up 14% from 2001 to 2003.[12] Another estimate was that the market in the United States was $126 billion and was increasing by about 4% annually.[10] American homes are aging; one estimate was that in 2007, more than half of all homes are older than 25 years.[12] And, as populations worldwide tend to become older, on average, and since increasingly elderly people will be less inclined and able to maintain their homes, it is likely that demand for handyman services will grow.[original research?][citation needed]
×