In theory, the cost of building-wide improvements should be less in a condo because it is spread out across dozens of residents, and the sheer scale of the project could lower the overall price. But it does not always work out that way. Condo board members are volunteers who may not be skilled negotiators or knowledgeable about construction. They may take the first bid they get, or agree to more work than is necessary. If complications increase the cost of the job, residents won’t necessarily know. “This is one of the potential downsides of a condo or co-op scheme,” said Eric D. Sherman, a real estate lawyer and partner in the New York office of Pryor Cashman. “Lots of the time, boards are under the gun. They’re not paid for their efforts, they take the first bid from the first contractor that they see and they say, ‘sign me up.’”   

If a screw turns but doesn’t tighten, the screw hole is stripped. Here’s a quick remedy: Remove the screw and hardware. Dip toothpicks in glue, jam as many as you can into the hole and break them off. You don’t have to wait for the glue to dry or drill new screw holes; just go ahead and reinstall the hardware by driving screws right into the toothpicks.
How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening 
the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with 
a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle 
anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill 
or a screwdriver, and then re­attach everything.

A garbage disposal is a bit scary when it’s turned on and the blades are noisily chopping up kitchen waste. But, if your disposal gets stinky, fear not. It’s easy to clean out the gunk and get rid of the smell. If the splash guard needs replacing, you can do that in 20 minutes! If you need to replace the entire disposal you can replace it yourself.


A variety of problems can befall your home’s doors, especially older doors that may start to sag, stick, develop drafts or experience other issues. Fixing or replacing a door is well within the capabilities of most homeowners, especially if you have a partner to help out. From installing new weather stripping to replacing the lock, you can handle it. Watch this video to see how simple it is to replace an interior door yourself.
For most people, the home is the biggest investment. Naturally, you want to protect that investment. Rather than waiting for what would have been a small inexpensive repair to grow into a much larger, more costly expense, you need to take preventive maintenance steps. If it has been a while since your home has been assessed, now is the time to have it checked out. Learn how Home Assessments can boost your Kansas City area home’s value.
Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.

Need your garage door repaired? Odds are, once you account for materials, labor and unforeseen hiccups, you’ll be writing a check for a grand. Your sump pump died? A new one could cost you around $600 for parts and labor, which doesn’t seem so bad considering the alternative is a flooded basement. But then the plumber might discover that the pipe carrying the water from the house to the street is clogged with years’ of debris and needs to be flushed out. And maybe there’s a blockage somewhere. There you have it: $1,000.
Silicone dries quickly and invisibly and doesn’t attract dirt, making it a good lubricant for drawer rollers, window tracks, door locks, bike parts, and other plastic, metal and rubber surfaces. It also helps protect metal against rust. Lithium grease is a long-lasting, weather-resistant (though somewhat messy) lubricant for garage door tracks, car doors and latches, and other metal parts that get heavy use outside. Check out 20 brilliant ways to use WD-40, another must-have lubricant for home repairs.
Many towns have handymen who work part-time, for friends or family or neighbors, who are skilled in a variety of tasks. Sometimes they advertise in newspapers or online. They vary in quality, professionalism, skill level, and price. Contractors often criticize the work of previous contractors, and this practice is not limited to handymen, but to all trades.[13] Handymen have advertised their services through flyers and mailings; in addition, free websites such as Craigslist and SkillSlate help customers and handymen find each other.[14]
Business Education Entertainment Government President Obama Visit 2009 General Election Health Live Healthy Non-Profit Sports Obituaries Pet Network Homeless Taskforce Weather Amherst Avon Avon Lake Elyria Grafton LaGrange Lorain North Ridgeville Oberlin Sheffield Lake Sheffield Village Vermilion Wellington LorainCounty.com Blog Digital Partners Advertise with Us Need Handyman Repairs? Click Here
×