To fix a squeaky floor under carpet, locate the floor joists with a stud finder, then drive in a trim head screw through the carpet, pad and subfloor, and right into the floor joist. Be sure the top inch of the screw doesn’t have threads or the subfloor won’t suck down tight to the joist. We like trim screws because screws with larger heads pull down and pucker the carpet. If that happens, back out the screw and drive it back down. Keep adding screws until the squeak stops. Try these other squeaky floor fixes.
In addition to the major tasks like painting, renovations, and replacements, we also do little jobs. Some of these include doorknob repair, bookshelves and built-ins, and hanging pictures and curtains. Other companies won’t perform this work, but we’re happy to do it all for you at a price you can afford. Our services are so inclusive that we’ll be the only ones you need to call whenever something goes amiss in your house.
If a screw turns but doesn’t tighten, the screw hole is stripped. Here’s a quick remedy: Remove the screw and hardware. Dip toothpicks in glue, jam as many as you can into the hole and break them off. You don’t have to wait for the glue to dry or drill new screw holes; just go ahead and reinstall the hardware by driving screws right into the toothpicks.
You're also less likely to be overcharged if your hire a handyman. Unlike a general contractor or specialist who is more likely to price a job based on the estimated amount of time it will take to complete, you only have to pay a handyman for the hours he works, unless you agree on a flat rate. Handymen can keep their rates low because they don't have to pay additional workers, so they have lower overhead costs than contractors or large companies.
An estimate was that in 2003, the market for home-maintenance and repair spending was up 14% from 2001 to 2003.[12] Another estimate was that the market in the United States was $126 billion and was increasing by about 4% annually.[10] American homes are aging; one estimate was that in 2007, more than half of all homes are older than 25 years.[12] And, as populations worldwide tend to become older, on average, and since increasingly elderly people will be less inclined and able to maintain their homes, it is likely that demand for handyman services will grow.[original research?][citation needed]
 This was our second use of the JW Home Improvement. The first time experience was wonderful. They were professional, did the job within agreed time and price, so we hired them again. This second experience was the polar opposite. We were seeking handyman services, but the estimator from JW turned each item on the list into a major job. We ended up with a coupon that we'd paid for, but no handyman services delivered, and no follow up call from the company to discuss. We ultimately hired another handyman who did a beautiful job within budget.

If you have a wallpaper seam that’s coming apart, reactivate the paste around the gap with a rag soaked in warm water. Hold the rag over the area for a minute or two, and then carefully open the gap a little larger so you’ll have more room for the sealer. Squeeze seam sealer (white glue works in a pinch) into the gap, and press the paper to the wall with a roller. Clean off the excess sealer with a sponge.

Examples of less frequent home maintenance that should be regularly forecast and budgeted include repainting or staining outdoor wood or metal, repainting masonry, waterproofing masonry, cleaning out septic systems, replacing sacrificial electrodes in water heaters, replacing old washing machine hoses (preferably with stainless steel hoses less likely to burst and cause a flood), and other home improvements such as replacement of obsolete or ageing systems with limited useful lifetimes (water heaters, wood stoves, pumps, and asphaltic or wooden roof shingles and siding.
Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.
How to DIY it: Gently tug the loose part of the carpet to find the point where it’s still attached. Snip 
it off as close to the backing as possible and save it. Use painter’s tape to surround the repair area. Squeeze 
a heavy bead of carpet seam sealer (about $6 at home centers) into the run. Then fill in the hole with the saved fiber, using a screwdriver to press it into the sealer bit by bit until the area looks like the surrounding 
carpet (below).
How to DIY it: Turn it off by opening the disconnect box (typically located on the outside wall near the unit) and pulling out the disconnect block inside (above). Now take a good look at the unit. If the vents are caked with fuzz from dandelions or cottonwood trees, vacuum the vents. Then rinse the unit with a hose using moderate pressure (the flimsy fins might bend under strong pressure). As you spray, peer down into the unit. You should see water streaming through. If not, the fins are still clogged, so keep rinsing.
How to DIY it: Turn it off by opening the disconnect box (typically located on the outside wall near the unit) and pulling out the disconnect block inside (above). Now take a good look at the unit. If the vents are caked with fuzz from dandelions or cottonwood trees, vacuum the vents. Then rinse the unit with a hose using moderate pressure (the flimsy fins might bend under strong pressure). As you spray, peer down into the unit. You should see water streaming through. If not, the fins are still clogged, so keep rinsing.
You'll get an email from your pro to confirm the date, time, and other details. Please be prepared to provide your pro the exact list of projects you would like them to complete and, wherever possible, related product URLs. During appointment scheduling, you will have the option to allow the provider to contact you to discuss the projects and tools needed in more detail.
Hello my name is Leo and about 22 years ago I entered the world of construction. Throughout the years I have learned many skills and I have used my skills to help people accomplish their projects. I am a father of 4 and family time is very important to me. My family and I started our own community garden where we teach other children how to grow their own garden.
When the kitchen faucet leaks, you can’t just call the super. Instead, you have to find a handyman willing to do the work — unless you want to figure out how fix it yourself. But that would mean spending half a day at Home Depot wandering around the plumbing aisle. Buy the wrong materials and you may be back at the store a week later, or calling that handyman anyway to fix your mistake. 
×