How to DIY it: Turn it off by opening the disconnect box (typically located on the outside wall near the unit) and pulling out the disconnect block inside (above). Now take a good look at the unit. If the vents are caked with fuzz from dandelions or cottonwood trees, vacuum the vents. Then rinse the unit with a hose using moderate pressure (the flimsy fins might bend under strong pressure). As you spray, peer down into the unit. You should see water streaming through. If not, the fins are still clogged, so keep rinsing.
This was our second use of the JW Home Improvement. The first time experience was wonderful. They were professional, did the job within agreed time and price, so we hired them again. This second experience was the polar opposite. We were seeking handyman services, but the estimator from JW turned each item on the list into a major job. We ended up with a coupon that we'd paid for, but no handyman services delivered, and no follow up call from the company to discuss. We ultimately hired another handyman who did a beautiful job within budget.
If a screw turns but doesn’t tighten, the screw hole is stripped. Here’s a quick remedy: Remove the screw and hardware. Dip toothpicks in glue, jam as many as you can into the hole and break them off. You don’t have to wait for the glue to dry or drill new screw holes; just go ahead and reinstall the hardware by driving screws right into the toothpicks.

For most people, the home is the biggest investment. Naturally, you want to protect that investment. Rather than waiting for what would have been a small inexpensive repair to grow into a much larger, more costly expense, you need to take preventive maintenance steps. If it has been a while since your home has been assessed, now is the time to have it checked out. Learn how Home Assessments can boost your Kansas City area home’s value.

How to DIY it: You should already be emptying the lint trap before every load of laundry. To do a thorough cleaning of the dryer and its vent duct system, unplug the machine (and turn off the gas valve if it has one). Pry off the access panel on the front (try a putty knife covered with duct tape to prevent scratching) and vacuum around the motor and heating element (above). Then carefully disconnect the vent duct tubing from the back of the dryer and use a dryer vent brush (about $10 at home 
centers; look for one that also cleans refrigerator coils) to pull out any 
accumulated lint. Aim to do this at least once a year.
When you hire a contractor or specialist, they usually supply the materials, and often at a markup. If they don't provide the materials, they may not guarantee a repair, or your choices are limited to what they have in stock. When you choose your own materials, you know how much the product costs, and you can stay within your budget. You also get to choose the manufacturer, finish and register any warranty agreement.
Instead of forking over $5,000-10,000 to replace all of your old windows with brand new ones, consider repairing old windows yourself. With a few hundred dollars in supplies (sand paper, paint, window glaze, etc.), you’ll be prepared to reglaze every window in your house. Though it can be a tad time consuming, you can prioritize the project by room, removing windows one by one to paint, reglaze, and, if necessary, replace any cracked glass. Get started glazing your windows here.
×