While you’re at it: Any appliance that uses water has a shutoff valve. But when valves go untouched for years, mineral deposits can make them impossible to close. Before that happens, locate the valves for your washer, ice maker, water heater, etc., and turn the handle (clockwise, about a quarter turn) every year or so (more often if your water is very hard), and then turn it back. Here are some ten-minute maintenance tasks you didn’t know you needed.
 José was quick to respond to my request for an estimate to install a new back door. He came over and sized it up, sent me a fair priced quote the next day, and was back with workers soon after I accepted the quote and immediately started working. I'm extremely satisfied with the work that was performed--and the door needed to be framed and set inside the metal frames for the house, which is a little more complex than a regular door installation. I will definitely hire Jose and Jireh Contractor again!

So last year, Mr. Hark and Mr. Larivee, who works in digital marketing, sold their condo and moved to a four-bedroom house, also in West Orange. They now have to mow their lawn and shovel their driveway when it snows, but when they had a drainage problem in the backyard, they got to choose their contractor and schedule the job based on when it made the most financial sense for them.
If you don’t cover paint chips with touch up paint, they’ll rust and then you’ll have a much bigger problem on your hands. The actual touch up is easy. Just buy touch up paint, fine tip paint applicators and wax and grease remover from any auto parts store. Clean the chip with the wax and grease remover and let it dry. Then dip the applicator in the paint and dab it onto the chip. Don’t add too much or the paint will drip. Let it dry completely and apply wax after 30 days. Get the full guide to using auto touch-up paint here.
Many an amateur DIY enthusiast has spotted a job that needs doing and gone out to buy the appropriate tools, only to find that they're way out of their league. Book a handyman using the Handy app or website and you can be sure that they'll arrive with everything they’ll need to get the job done. In addition to your run-of-the-mill screwdrivers and hammers, your handyman specialist will read your job description before they arrive to ensure they come prepared for anything that your specific job may require. Don't worry about whether you’ve got the right tools for the job. Book a handyman through Handy and leave it to the professionals.

If a screw turns but doesn’t tighten, the screw hole is stripped. Here’s a quick remedy: Remove the screw and hardware. Dip toothpicks in glue, jam as many as you can into the hole and break them off. You don’t have to wait for the glue to dry or drill new screw holes; just go ahead and reinstall the hardware by driving screws right into the toothpicks.


There’s nothing worse than starting a sink or toilet repair only to find that the shutoff valve won’t shut off. Some shutoff valves are easy to replace. For those that aren’t, turn off the main water valve, remove the packing nut, and then unscrew the stem and take it to the hardware store to find a replacement washer. Clean any grit out of the valve body and pop on the new washer. The valve will work like new.
Tiny holes in shingles are sneaky because they can cause rot, a leaky roof and other damage for years before you notice the obvious signs of a leak. You might find holes left over from a satellite dish or antenna mounting brackets or just about anything. And exposed, misplaced roofing repair nails should be pulled and the holes patched. Small holes are simple to fix, but the fix isn’t to inject caulk in the hole. You’ll fix this leaky roof problem with flashing.
To fix a squeaky floor under carpet, locate the floor joists with a stud finder, then drive in a trim head screw through the carpet, pad and subfloor, and right into the floor joist. Be sure the top inch of the screw doesn’t have threads or the subfloor won’t suck down tight to the joist. We like trim screws because screws with larger heads pull down and pucker the carpet. If that happens, back out the screw and drive it back down. Keep adding screws until the squeak stops. Try these other squeaky floor fixes.

PWC provides critical – not cosmetic – home repair services to its clients. This type of home maintenance is performed by PWC’s trained, licensed and bonded staff of skilled tradesmen, including plumbers, electricians, carpenters, and HVAC technicians. Depending on your location and your specific needs, below are some of the services you could receive:
You may qualify if all of the following apply to your household:A child under six resides in your home or spends at least six hours per week in your home on a regular basis You have owned and lived in your home for more than one yearYour home was built before 1978You live in one of these city neighborhoods:Bond Hill, Westend, Over-The-Rhine, Mt. Auburn, CUF, Corryville, Madisonville, Avondale, South Cumminsville, North and South Fairmount, West, East and Lower Price Hill, Walnut Hills, Evanston Northside or Carthage

How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts. 
×