An estimate was that in 2003, the market for home-maintenance and repair spending was up 14% from 2001 to 2003.[12] Another estimate was that the market in the United States was $126 billion and was increasing by about 4% annually.[10] American homes are aging; one estimate was that in 2007, more than half of all homes are older than 25 years.[12] And, as populations worldwide tend to become older, on average, and since increasingly elderly people will be less inclined and able to maintain their homes, it is likely that demand for handyman services will grow.[original research?][citation needed]


How to DIY it: There are lots of ways to clear a drain, so start with the easiest one. If your sink has a pop-up stopper, remove that and clean it. If that doesn’t do the trick, fill the sink with 3 or 4 inches of water and use a plunger to plunge the sink (plug the overflow hole with a wet rag first). Still slow? Try snaking the drain pipe with a metal hanger or a pipe-cleaning tool (sold at hardware stores for about $2).
Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.
Ms. Artale in Westchester has a plan to fix the problem. Neither she nor her husband, Andy, 41, a program analyst, may ever learn how to repair a fence. But that won’t be the case with their 9-year-old son, Matteo. “When my son gets a little older, I’m going to apprentice him out to someone — for real,” she said. “It’s ridiculous that my husband and I don’t know how to do anything.”

Two-part filler has to be mixed and it doesn’t rinse off with water, so it’s not as user friendly as other fillers. However, it’s much tougher and a much better choice for any hole bigger than a nail head, especially outdoors. And it’s not just for wood?you can patch metal, fiberglass?even concrete. Here’s another option for wood filler. Buy some wood filler on Amazon now.
Risk: If your house was built 
before 1994 and still has the original plumbing fixtures, you’re using 
30 to 40 percent more water than 
a comparable new home. Because about 70 percent of the water flowing through the showerhead is hot, 
that means higher heating bills too. A basic showerhead can cost just $15 and could pay for itself in reduced water and heating costs after just one month. Calculate your 
savings at epa.gov/watersense/watersense-calculator.
With Grandma’s handymen in Aurora, Parker, Highlands Ranch and Denver, handyman help is just a phone call away! Our Denver handyman staff specializes in home maintenance and repair, and is experienced in a variety of trades including plumbing, painting, drywall, electrical, and carpentry. Click here for a list of our handyman services in Aurora, Denver, Parker, Highlands Ranch, Lone Tree, Centennial, Littleton, Lakewood, and Englewood.
How to DIY it: Turn it off by opening the disconnect box (typically located on the outside wall near the unit) and pulling out the disconnect block inside (above). Now take a good look at the unit. If the vents are caked with fuzz from dandelions or cottonwood trees, vacuum the vents. Then rinse the unit with a hose using moderate pressure (the flimsy fins might bend under strong pressure). As you spray, peer down into the unit. You should see water streaming through. If not, the fins are still clogged, so keep rinsing.
While you’re at it: If you don’t have a programmable thermostat, consider getting one. According to the U.S. Department of Energy, an Energy Star–rated model can save you about $180 in heating and cooling costs each year. You can buy one for about $40 and install it yourself. It’s a relatively easy job; no rewiring required. On the other hand, these are home improvement projects you should never, ever DIY.
At Home Handyman Services provides a variety of services such as maintenance, safety and convenience modifications for people who choose to remain independent in their own homes. Our goal is to assist seniors and their families with maintaining a safe and comfortable living environment. Our carefully screened service providers can help with the following:
When the kitchen faucet leaks, you can’t just call the super. Instead, you have to find a handyman willing to do the work — unless you want to figure out how fix it yourself. But that would mean spending half a day at Home Depot wandering around the plumbing aisle. Buy the wrong materials and you may be back at the store a week later, or calling that handyman anyway to fix your mistake.
×