How to DIY it: There are lots of ways to clear a drain, so start with the easiest one. If your sink has a pop-up stopper, remove that and clean it. If that doesn’t do the trick, fill the sink with 3 or 4 inches of water and use a plunger to plunge the sink (plug the overflow hole with a wet rag first). Still slow? Try snaking the drain pipe with a metal hanger or a pipe-cleaning tool (sold at hardware stores for about $2).
It is not uncommon for power switches and breakers to be accidentally turned off when other appliances are being installed. Homeowners are encouraged to check their circuit breaker to make sure the issue isn’t as simple as needing to turn a switch back on. A circuit breaker is typically located in the garage, although in some homes, the circuit breaker can be found in the basement, hallway or storage room.
Generally the job of paid handyman is low status, a semi-skilled labor job. It's a less prestigious occupation than a specialist such as a plumber, electrician, or carpenter. With the emergence of large national chains, an effort is being made to change that perception, by emphasizing professionalism and the fact that a handyman is actually a technician with multiple skills and a wide range of knowledge. At the same time, unpaid homeowners skilled at repairs are valued for saving money. And handyman tools sometimes become useful in different places: for example, when a proper neurological drill was not available, an Australian doctor used a handyman's drill in 2009 to open a hole in the head of a 13-year-old boy to relieve pressure after a brain injury; the boy's life was saved.[11]
If you can see light creeping beneath exterior doors, air is also escaping. Grab a few packages of self-adhesive rubber foam weatherstripping and go to town, sealing any and all doors that lead outside. Weatherstripping already installed but you’re still suffering from a high gas bill? It might be time to replace the strips installed by the previous owners. Check out this handy tutorial on installing weatherstripping.

PWC provides critical – not cosmetic – home repair services to its clients. This type of home maintenance is performed by PWC’s trained, licensed and bonded staff of skilled tradesmen, including plumbers, electricians, carpenters, and HVAC technicians. Depending on your location and your specific needs, below are some of the services you could receive:
Comment: I need to have two smoke detectors installed, One is in the master bedroom (vaulted ceiling) and one in the basement. I need 4 lights installed in the kitchen (vaulted ceiling). I need the battery replaced in the smoke detector in the living room (vaulted ceiling). Lastly, I would like the light bulbs replaced in 4 ceiling fans. They are in the florida room, living room (vaulted ceiling), master bedroom (vaulted ceiling), and second bedroom.
Sussex County Habitat for Humanity offers a Home Repair Program that performs repair services to help low-income homeowners impacted by age, disability and family circumstances reclaim their homes with pride and dignity. Volunteer teams work to improve the condition of homes by painting, landscaping, and performing minor repairs at minimal costs to homeowners who would otherwise be unable to complete home repairs on their own.  In addition, SCHFH now offers home repair and renovation services on a larger scale that aim to alleviate critical health, life and safely issues.  Able-bodied homeowners are asked to work alongside the volunteers in a cooperative effort.
Cracking grout in a newly tiled floor is a real letdown after all the work you put into it. The causes could range from a poor grout mix to a lack of expansion joints, to movement of the tiled surface. Although it might ultimately be necessary to stiffen the floor, you can first try using caulk as flexible grout. Find out more in this comprehensive article.

From the beginning these guys were great. I received a text message asking me for all of the work I would like to be done. I initially only needed the service to mount my over the range microwave but because of his swift service, I was able to install floating shelves and a wine rack. There was communication all throughout the process and I loved how honest they were when they weren't 100% sure if they could do my microwave. Other than that, my son loved the handyman and walked around the apartment with our measuring tape telling me how may units things were. Loved the service and will definitely book again!
How to DIY it: A simple cleaning often solves the problem. Start by pulling out the lower dish rack. 
Remove the spray arm and use a thin piece of wire to clean out the holes where water sprays through. Scoop or vacuum out any leftover food 
particles from the filter area, then 
remove the filter screen (above), if possible, and give it a good rinse.
How to DIY it: Gently tug the loose part of the carpet to find the point where it’s still attached. Snip 
it off as close to the backing as possible and save it. Use painter’s tape to surround the repair area. Squeeze 
a heavy bead of carpet seam sealer (about $6 at home centers) into the run. Then fill in the hole with the saved fiber, using a screwdriver to press it into the sealer bit by bit until the area looks like the surrounding 
carpet (below).
How to DIY it: Clean up any rough edges around the hole, then stick the patch onto the wall over the hole (left). Using the taping knife, spread a layer of joint compound over it and let it dry overnight. Then spread a wider second coat, feathering out the compound on all sides to make the patch blend in. Let it dry, then apply one more coat extending 8 to 12 inches beyond the patch in 
all directions. After the final coat dries, sand the area with a sanding sponge (a foam block wrapped in sand­paper) until it feels smooth and even. Prime, and then paint.

Need your garage door repaired? Odds are, once you account for materials, labor and unforeseen hiccups, you’ll be writing a check for a grand. Your sump pump died? A new one could cost you around $600 for parts and labor, which doesn’t seem so bad considering the alternative is a flooded basement. But then the plumber might discover that the pipe carrying the water from the house to the street is clogged with years’ of debris and needs to be flushed out. And maybe there’s a blockage somewhere. There you have it: $1,000.
You'll get an email from your pro to confirm the date, time, and other details. Please be prepared to provide your pro the exact list of projects you would like them to complete and, wherever possible, related product URLs. During appointment scheduling, you will have the option to allow the provider to contact you to discuss the projects and tools needed in more detail.
How to DIY it: Coils are located 
on the back of the refrigerator or across the bottom. Pull the fridge away from the wall. (Hint: Grab the sides and pull from the bottom. You may want to lay cardboard on the floor first to prevent scratching.) Clean coils with a coil-cleaning brush (about $10 at home centers), then vacuum. Do this every six months or so.
How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.

If you find that drawer slides are bent, rollers are broken or rollers won’t turn even after lubricating, replacement is the best solution. To keep the project simple, buy new slides that are identical (or almost identical) to the old ones. That way, replacement is an easy matter of unscrewing the old and screwing on the new. Remove a drawer track and a cabinet track and take them shopping with you. Learn how to build an under-cabinet drawer here.

You'll get an email from your pro to confirm the date, time, and other details. Please be prepared to provide your pro the exact list of projects you would like them to complete and, wherever possible, related product URLs. During appointment scheduling, you will have the option to allow the provider to contact you to discuss the projects and tools needed in more detail.
×