How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill or a screwdriver, and then reattach everything.
Check for cracked housings on plastic roof vents and broken seams on metal ones. You might be tempted to throw caulk at the problem, but that solution won’t last long. There’s really no fix other than replacing the damaged vents. Also look for pulled or missing nails at the base’s bottom edge. Replace them with rubber-washered screws. In most cases, you can remove nails under the shingles on both sides of the vent to pull it free. There will be nails across the top of the vent too. Usually you can also work those loose without removing shingles. Screw the bottom in place with rubber-washered screws. Squeeze out a bead of caulk beneath the shingles on both sides of the vent to hold the shingles down and to add a water barrier. That’s much easier than renailing the shingles.
So last year, Mr. Hark and Mr. Larivee, who works in digital marketing, sold their condo and moved to a four-bedroom house, also in West Orange. They now have to mow their lawn and shovel their driveway when it snows, but when they had a drainage problem in the backyard, they got to choose their contractor and schedule the job based on when it made the most financial sense for them.
Need your garage door repaired? Odds are, once you account for materials, labor and unforeseen hiccups, you’ll be writing a check for a grand. Your sump pump died? A new one could cost you around $600 for parts and labor, which doesn’t seem so bad considering the alternative is a flooded basement. But then the plumber might discover that the pipe carrying the water from the house to the street is clogged with years’ of debris and needs to be flushed out. And maybe there’s a blockage somewhere. There you have it: $1,000.
You’ve got an ever increasing to-do list of home improvements like changing out a bathroom faucet, replacing missing shingles on the roof and painting a kitchen wall. You could hire a plumber, roofer and painter who have conflicting schedules and their own service charges, or you could hire a handyman to complete all three projects in one day for one hourly rate.
Quick-setting drywall compound lets you finish small repairs and fill deep holes in minutes instead of waiting days for premixed joint compound to dry. The small boxes are available in most home centers and paint stores are also easier to store and more likely to get used up than large bags or buckets. Click here to learn how to hang drywall like a pro. Click here to buy drywall compound on Amazon now.
How to DIY it: Turn it off by opening the disconnect box (typically located on the outside wall near the unit) and pulling out the disconnect block inside (above). Now take a good look at the unit. If the vents are caked with fuzz from dandelions or cottonwood trees, vacuum the vents. Then rinse the unit with a hose using moderate pressure (the flimsy fins might bend under strong pressure). As you spray, peer down into the unit. You should see water streaming through. If not, the fins are still clogged, so keep rinsing.
If you find that drawer slides are bent, rollers are broken or rollers won’t turn even after lubricating, replacement is the best solution. To keep the project simple, buy new slides that are identical (or almost identical) to the old ones. That way, replacement is an easy matter of unscrewing the old and screwing on the new. Remove a drawer track and a cabinet track and take them shopping with you. Learn how to build an under-cabinet drawer here.
My name is Troy I'm a carpenter by trade with the exception of my first year out of high school I spent as a taping Apprentice and three semesters I worked painting when I was in college, its all I've ever done. I also do furniture assembly some Plumbing and Electrical (installing gfi's,ceiling fans, switching out plugs and switches)& a little HVAC.
Many towns have handymen who work part-time, for friends or family or neighbors, who are skilled in a variety of tasks. Sometimes they advertise in newspapers or online. They vary in quality, professionalism, skill level, and price. Contractors often criticize the work of previous contractors, and this practice is not limited to handymen, but to all trades. Handymen have advertised their services through flyers and mailings; in addition, free websites such as Craigslist and SkillSlate help customers and handymen find each other.
Though it can seem intimidating, installing your own batting installation can be easy, and take just a few hours if you isolate the need to a few key spaces. Have a drafty attic? Start there. Concerned about a freezing crawl space? Throw on your work jeans and get to work. These insulating spaces will instantly feel warmer and you’ll notice the savings on your next heating bill. Read how to install insulation here.
When a home is sold, inspections are performed that may reveal environmental hazards such as radon gas in the basement or water supply or friable asbestos materials (both of which can cause lung cancer), peeling or disturbed lead paint (a risk to children and pregnant women), in-ground heating oil tanks that may contaminate ground water, or mold that can cause problems for those with asthma or allergies. Typically the buyer or mortgage lender will require these conditions to be repaired before allowing the purchase to close. An entire industry of environmental remediation contractors has developed to help home owners resolve these types of problems.
The handyman image recurs in popular culture. There have been songs about handymen recorded by Elvis Presley in 1964, Del Shannon in 1964, James Taylor in 1977. There are femme-fatale TV characters who fall for handymen. Handymen have been portrayed in books and films, generally positively, as do-gooder helpful types, but not particularly smart or ambitious. In a book by author Carolyn See called The Handyman, a handyman is really an aspiring but discouraged artist who transforms the lives of people he works for, as well as having sexual encounters with some of his clients, and his experiences improve his artistic output. The book suggests handymen discover "the appalling loneliness of the women who call him for help" whose needs are sometimes "comic," sometimes "heartbreaking," and deep down "sexual". A 1980 movie called The Handyman was about a carpenter-plumber who was "good at what he does" but is "too honest and trusting," and gets taken advantage of by "women who find him handsome and understanding;" the movie earned negative reviews from critic Vincent Canby. Other movies have used a rather tired formula of sexy-handyman meets bored-housewives, such as The Ups and Downs of a Handyman, a 1975 movie in which "Handsome Bob also finds he's a fast favorite with the local housewives, who seem to have more than small repairs on their minds." In Canada, there's a television show called Canada's Worst Handyman which is a reality show in which handyman contestants try their best on jobs in order to not be labeled worst handyman. Home Improvement is an American television sitcom starring Tim Allen, which aired 1991 to 1999. On the children's television show Mister Rogers' Neighborhood, Handyman Negri was one of the characters residing in The Neighborhood of Make-Believe, as well as the neighborhood Mister Rogers resides in. Handy Manny is an American/Hispanic preschool television show that airs on Disney Junior and stars a handy man cartoon character named Manny. The Belgian comics and media franchise The Smurfs depicts Handy Smurf with traditional handyman's accoutrements, such as overalls, carpenter's pencil and work hat. Happy Tree Friends also has an orange beaver named Handy who is a handyman.
Instead of forking over $5,000-10,000 to replace all of your old windows with brand new ones, consider repairing old windows yourself. With a few hundred dollars in supplies (sand paper, paint, window glaze, etc.), you’ll be prepared to reglaze every window in your house. Though it can be a tad time consuming, you can prioritize the project by room, removing windows one by one to paint, reglaze, and, if necessary, replace any cracked glass. Get started glazing your windows here.