Before you go through the trouble of repainting a ceiling to get rid of a water stain, try this trick. Spray the spot with a bleach and water solution (10 percent bleach), and wait a day or two. If it’s an old stain, use a mold and mildew remover from the grocery store. You’d be surprised how often the stain disappears by the next day. It works on both flat and textured ceilings.
If you have shallow scratches or nicks, hide them with a stain-filled touch-up marker. Dab on the stain and wipe off the excess with a rag. But beware: Scratches can absorb lots of stain and turn darker than the surrounding finish. So start with a marker that’s lighter than your cabinet finish and then switch to a darker shade if needed. For deeper scratches, use a filler pencil, which fills and colors the scratch. Or, try using a walnut to remove scratches in wood!

You may qualify if all of the following apply to your household:A child under six resides in your home or spends at least six hours per week in your home on a regular basis You have owned and lived in your home for more than one yearYour home was built before 1978You live in one of these city neighborhoods:Bond Hill, Westend, Over-The-Rhine, Mt. Auburn, CUF, Corryville, Madisonville, Avondale, South Cumminsville, North and South Fairmount, West, East and Lower Price Hill, Walnut Hills, Evanston Northside or Carthage
While you’re at it: Any appliance that uses water has a shutoff valve. But when valves go untouched for years, mineral deposits can make them impossible to close. Before that happens, locate the valves for your washer, ice maker, water heater, etc., and turn the handle (clockwise, about a quarter turn) every year or so (more often if your water is very hard), and then turn it back. Here are some ten-minute maintenance tasks you didn’t know you needed.
How to DIY it: Turn it off by opening the disconnect box (typically located on the outside wall near the unit) and pulling out the disconnect block inside (above). Now take a good look at the unit. If the vents are caked with fuzz from dandelions or cottonwood trees, vacuum the vents. Then rinse the unit with a hose using moderate pressure (the flimsy fins might bend under strong pressure). As you spray, peer down into the unit. You should see water streaming through. If not, the fins are still clogged, so keep rinsing.
When you hire a contractor or specialist, they usually supply the materials, and often at a markup. If they don't provide the materials, they may not guarantee a repair, or your choices are limited to what they have in stock. When you choose your own materials, you know how much the product costs, and you can stay within your budget. You also get to choose the manufacturer, finish and register any warranty agreement.
Comment: I need to have two smoke detectors installed, One is in the master bedroom (vaulted ceiling) and one in the basement. I need 4 lights installed in the kitchen (vaulted ceiling). I need the battery replaced in the smoke detector in the living room (vaulted ceiling). Lastly, I would like the light bulbs replaced in 4 ceiling fans. They are in the florida room, living room (vaulted ceiling), master bedroom (vaulted ceiling), and second bedroom.
×