Check for cracked housings on plastic roof vents and broken seams on metal ones. You might be tempted to throw caulk at the problem, but that solution won’t last long. There’s really no fix other than replacing the damaged vents. Also look for pulled or missing nails at the base’s bottom edge. Replace them with rubber-washered screws. In most cases, you can remove nails under the shingles on both sides of the vent to pull it free. There will be nails across the top of the vent too. Usually you can also work those loose without removing shingles. Screw the bottom in place with rubber-washered screws. Squeeze out a bead of caulk beneath the shingles on both sides of the vent to hold the shingles down and to add a water barrier. That’s much easier than renailing the shingles.


If you’re looking for a Denver handyman who can fix a leaking faucet, replace a faulty light switch, put in a new toilet or shower, patch or replace drywall, install or build some shelving, put in a ceiling fan, paint a room, repair a fence, build a closet, or perform pretty much any other maintenance or repair project . . . Grandma’s Handyman Service in Denver can help!
If you don’t cover paint chips with touch up paint, they’ll rust and then you’ll have a much bigger problem on your hands. The actual touch up is easy. Just buy touch up paint, fine tip paint applicators and wax and grease remover from any auto parts store. Clean the chip with the wax and grease remover and let it dry. Then dip the applicator in the paint and dab it onto the chip. Don’t add too much or the paint will drip. Let it dry completely and apply wax after 30 days. Get the full guide to using auto touch-up paint here.
A handyman is not the best option for a large or complicated project that could take a long time to complete and requires the help of multiple workers. You shouldn't turn to a handyman either if you need an emergency service for plumbing, electrical or appliance work, unless the handyman is licensed in that trade. If an unlicensed person does plumbing or electrical work, you have no guarantee that the work has been done to code, which could affect your homeowners insurance policy or any claim related to the work. Use a contractor or specialist for remodeling work, room additions and projects that require heavy-duty equipment or licensed professionals like electricians.
If a screw turns but doesn’t tighten, the screw hole is stripped. Here’s a quick remedy: Remove the screw and hardware. Dip toothpicks in glue, jam as many as you can into the hole and break them off. You don’t have to wait for the glue to dry or drill new screw holes; just go ahead and reinstall the hardware by driving screws right into the toothpicks.
Quick-setting drywall compound lets you finish small repairs and fill deep holes in minutes instead of waiting days for premixed joint compound to dry. The small boxes are available in most home centers and paint stores are also easier to store and more likely to get used up than large bags or buckets. Click here to learn how to hang drywall like a pro. Click here to buy drywall compound on Amazon now.

Everything was simply unforgettable! I responded to an ad for Black Friday Special: name your price for the job with no reasonable offer refused! I emailed the company letting them know I wanted some rotten wood replaced on the window dormer and a ceiling repaired and painted. Mike said he would trust what and wanted and the price of $400.00. The carpenter and the painter arrived early. Mike arrived shortly and went over what needed to be done. I had purchased treated lumber so Mike purchased with receipt the correct wood. The carpenter quickly saw that more rotten wood had to be replaced than anticipated. The carpenter had to do wood cutting to frame and restore the dormer as well as insulate, caulk and prime the untreated wood. Needless to say, the handyman special turned out to be a skillful carpentry job. Mike, nevertheless kept the price at $400.00, which also included the plaster repair for the ceiling as well as painting the entire ceiling. I had been told in the past by two contractors that the ceiling job was complicated. Mike and his painter made the job uncomplicated and the result was simply great!


Comment: I need to have two smoke detectors installed, One is in the master bedroom (vaulted ceiling) and one in the basement. I need 4 lights installed in the kitchen (vaulted ceiling). I need the battery replaced in the smoke detector in the living room (vaulted ceiling). Lastly, I would like the light bulbs replaced in 4 ceiling fans. They are in the florida room, living room (vaulted ceiling), master bedroom (vaulted ceiling), and second bedroom.
If you can’t see any telltale flow marks, and since the stain is fairly small, look at the underside of the roof for ‘shiners.’ A shiner is a nail that missed the framing member, in this case when the carpenter nailed the roof sheathing to the rafters. Moisture that escapes into the cold attic from the rooms below often condenses on cold nails. Sometimes you can spot this if you climb up into your attic on a cold night. The nails will look white because they’re frosted. When the attic heats up a bit during the day, the frost melts and drips, then the nails frost up at night again and so on. The solution is to simply clip the nail with a side-cutting pliers.

A 2018 HomeAdvisor survey found that homeowners underestimated the cost of fixing or updating just about everything in their homes. When it came to interior painting, for example, survey participants estimated the work would cost $734. But the national average is $1,744. One of the few items they overestimated was a new toilet — the average is $370, not $405.
JW were very prompt to reply to our initial quote request in which we described using the master shower caused water to pour down the HVAC return duct and was collecting within the walls and causing water damage on the first floor and in the basement ceiling. We also reached out to see if they could resolve a water issue in a corner of the basement that had become oversaturated during the heavy DC rains this summer causing heavy mold within the insulation and a few rotted studs (in addition to moldy drywall). Josh quickly scheduled a time to come out and take a look at the situation and provided great upfront information regarding what he thought the issue might be (initially believed a ripped rubber liner in the shower), price estimate, and description of the teams they use to work on projects. He estimated 2 workers over 3-4 days for $5,952.00 to $7,936.00 dependent on the severity of the issue and materials required. Once we scheduled the work, Cesar was out on time (a little early every day) from Monday through midday Wednesday. On site Cesar let me know the issue actually seemed to be bad grouting and caulking from the original house flippers. He offered to re-grout the entire shower and re-caulk, then test the shower instead of tearing up the stone tile on the floor. The next day we tested the shower for 10-15 minutes and no leak! Luckily for us the issue was smaller than expected which saved us a lot of hassle and money and I'm glad he opted to try that before blindly tearing up the shower. Beyond the high quality of work in general, a few things stood out in my mind as to how customer-oriented JW is: 1) Cesar constantly checked in if he wanted our opinion on things before moving forward. 2) Within the main leak area, he sprayed anti-fungal solution to prevent residual build up. 3) In the basement leak area, they sprayed base-level drylock to help prevent further issues. 4) We had plans to paint the areas they worked on so we didn't require they to repaint but it was offered to us. When they learned we planned on painting, they primed the area so it was ready for us when we got to painting it. 5) The cleanup crew collected all leftover materials and some extra left by the original flippers. Overall the project came in under budget and under timeline. We were exceptionally pleased with JW and will continue to use them as we need services like theirs.
There's no national standard or regulation for handymen. Licensing and regulation vary by state. New Jersey, for example, requires handymen who work for a profit to register with the state and carry insurance. California requires handymen to carry a license from the State Contractors License Board to work on any project that exceeds $500 in labor and material costs. Find out before you hire the handyman if he or she has the skills needed to complete your project.
Though it can seem intimidating, installing your own batting installation can be easy, and take just a few hours if you isolate the need to a few key spaces. Have a drafty attic? Start there. Concerned about a freezing crawl space? Throw on your work jeans and get to work. These insulating spaces will instantly feel warmer and you’ll notice the savings on your next heating bill. Read how to install insulation here.
There's no national standard or regulation for handymen. Licensing and regulation vary by state. New Jersey, for example, requires handymen who work for a profit to register with the state and carry insurance. California requires handymen to carry a license from the State Contractors License Board to work on any project that exceeds $500 in labor and material costs. Find out before you hire the handyman if he or she has the skills needed to complete your project.
Business Education Entertainment Government President Obama Visit 2009 General Election Health Live Healthy Non-Profit Sports Obituaries Pet Network Homeless Taskforce Weather Amherst Avon Avon Lake Elyria Grafton LaGrange Lorain North Ridgeville Oberlin Sheffield Lake Sheffield Village Vermilion Wellington LorainCounty.com Blog Digital Partners Advertise with Us Need Handyman Repairs? Click Here
×