While you’re at it: If you don’t have a programmable thermostat, consider getting one. According to the U.S. Department of Energy, an Energy Star–rated model can save you about $180 in heating and cooling costs each year. You can buy one for about $40 and install it yourself. It’s a relatively easy job; no rewiring required. On the other hand, these are home improvement projects you should never, ever DIY.
It is not uncommon for power switches and breakers to be accidentally turned off when other appliances are being installed. Homeowners are encouraged to check their circuit breaker to make sure the issue isn’t as simple as needing to turn a switch back on. A circuit breaker is typically located in the garage, although in some homes, the circuit breaker can be found in the basement, hallway or storage room.
Comment: I need to have two smoke detectors installed, One is in the master bedroom (vaulted ceiling) and one in the basement. I need 4 lights installed in the kitchen (vaulted ceiling). I need the battery replaced in the smoke detector in the living room (vaulted ceiling). Lastly, I would like the light bulbs replaced in 4 ceiling fans. They are in the florida room, living room (vaulted ceiling), master bedroom (vaulted ceiling), and second bedroom.
Here’s a quick fix for a drawer front that’s pulling off. Cut a couple of lengths of quarter-round the same height as the drawer sides. Hold them in place while you drill a couple of holes through the sides and front of the drawer box. Dab some polyurethane glue (wood glue doesn’t stick well to finished surfaces) on the pieces of quarter-round before screwing them into place. Here’s how to fix sticky wooden drawers.
Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.
Examples of less frequent home maintenance that should be regularly forecast and budgeted include repainting or staining outdoor wood or metal, repainting masonry, waterproofing masonry, cleaning out septic systems, replacing sacrificial electrodes in water heaters, replacing old washing machine hoses (preferably with stainless steel hoses less likely to burst and cause a flood), and other home improvements such as replacement of obsolete or ageing systems with limited useful lifetimes (water heaters, wood stoves, pumps, and asphaltic or wooden roof shingles and siding.
Many an amateur DIY enthusiast has spotted a job that needs doing and gone out to buy the appropriate tools, only to find that they're way out of their league. Book a handyman using the Handy app or website and you can be sure that they'll arrive with everything they’ll need to get the job done. In addition to your run-of-the-mill screwdrivers and hammers, your handyman specialist will read your job description before they arrive to ensure they come prepared for anything that your specific job may require. Don't worry about whether you’ve got the right tools for the job. Book a handyman through Handy and leave it to the professionals.
José was quick to respond to my request for an estimate to install a new back door. He came over and sized it up, sent me a fair priced quote the next day, and was back with workers soon after I accepted the quote and immediately started working. I'm extremely satisfied with the work that was performed--and the door needed to be framed and set inside the metal frames for the house, which is a little more complex than a regular door installation. I will definitely hire Jose and Jireh Contractor again!
Risk: If your house was built 
before 1994 and still has the original plumbing fixtures, you’re using 
30 to 40 percent more water than 
a comparable new home. Because about 70 percent of the water flowing through the showerhead is hot, 
that means higher heating bills too. A basic showerhead can cost just $15 and could pay for itself in reduced water and heating costs after just one month. Calculate your 
savings at epa.gov/watersense/watersense-calculator.

Grandma’s Handyman Service provides homeowners and businesses with superior handyman services at affordable prices. Our happy customers give us lots of repeat business and lots of nice compliments. But don’t take our word for it! Click here to read what our happy handyman customers have to say. And then call us today for minor or major repairs, small remodeling projects or just to finally get that honey-do list completed!
Carefully screened by Grandma herself before being hired, every handyman employed by Grandma’s has passed a national background check. Grandma's Handyman Service, Inc. is also fully insured and bonded. This means that our customers and our employees are protected. We’re also a member of the Better Business Bureau, which is your assurance of our good business practices. Our Denver handyman service is covered by liability insurance, worker’s compensation insurance and a surety bond. Our handymen are direct employees, not subcontractors or a referral service. Our Denver handyman service works because all our handymen have to answer to directly to Grandma!
How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.
×