Cracking grout in a newly tiled floor is a real letdown after all the work you put into it. The causes could range from a poor grout mix to a lack of expansion joints, to movement of the tiled surface. Although it might ultimately be necessary to stiffen the floor, you can first try using caulk as flexible grout. Find out more in this comprehensive article.
Quick-setting drywall compound lets you finish small repairs and fill deep holes in minutes instead of waiting days for premixed joint compound to dry. The small boxes are available in most home centers and paint stores are also easier to store and more likely to get used up than large bags or buckets. Click here to learn how to hang drywall like a pro. Click here to buy drywall compound on Amazon now.

Sooner or later, every sprayed ceiling is going to get a water stain or a scrape. Spray texture in a can won’t perfectly match every ceiling texture, but it’s usually close, and a lot easier than respraying a whole ceiling. Before spraying, seal the patch with a stain-blocking primer, cover the floor and furniture, and practice your technique on scrap plywood or cardboard. Buy ceiling texture on Amazon now.

Handyman.com helps you find an experienced, professional Handyman contractor in your local area, FREE, NO OBLIGATIONS. Handyman.com is the industry leading portal for the home improvement, home repair and remodeling industry. Our free tools and services help both homeowners and contractors facilitate the process to accomplish your home repair and remodeling needs. Serving the Home and Contractor market. Why use our pros?
So a door knob slammed through the wall after one too many times slamming the door. No need to call your handy contractor. You can easily fix a few holes in your drywall by injecting a setting compound (for smaller holes) or by cutting out the damaged sections and replacing them with new drywall (for larger ones). Check out this handy tutorial for more on repairing holes.
Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.

How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening 
the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with 
a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle 
anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill 
or a screwdriver, and then re­attach everything.
There’s nothing worse than starting a sink or toilet repair only to find that the shutoff valve won’t shut off. Some shutoff valves are easy to replace. For those that aren’t, turn off the main water valve, remove the packing nut, and then unscrew the stem and take it to the hardware store to find a replacement washer. Clean any grit out of the valve body and pop on the new washer. The valve will work like new.
How to DIY it: You should already be emptying the lint trap before every load of laundry. To do a thorough cleaning of the dryer and its vent duct system, unplug the machine (and turn off the gas valve if it has one). Pry off the access panel on the front (try a putty knife covered with duct tape to prevent scratching) and vacuum around the motor and heating element (above). Then carefully disconnect the vent duct tubing from the back of the dryer and use a dryer vent brush (about $10 at home 
centers; look for one that also cleans refrigerator coils) to pull out any 
accumulated lint. Aim to do this at least once a year.
It is not uncommon for power switches and breakers to be accidentally turned off when other appliances are being installed. Homeowners are encouraged to check their circuit breaker to make sure the issue isn’t as simple as needing to turn a switch back on. A circuit breaker is typically located in the garage, although in some homes, the circuit breaker can be found in the basement, hallway or storage room.

It is not uncommon for power switches and breakers to be accidentally turned off when other appliances are being installed. Homeowners are encouraged to check their circuit breaker to make sure the issue isn’t as simple as needing to turn a switch back on. A circuit breaker is typically located in the garage, although in some homes, the circuit breaker can be found in the basement, hallway or storage room.
The handyman image recurs in popular culture. There have been songs about handymen recorded by Elvis Presley in 1964, Del Shannon in 1964, James Taylor in 1977.[22] There are femme-fatale TV characters who fall for handymen.[23] Handymen have been portrayed in books and films, generally positively, as do-gooder helpful types, but not particularly smart or ambitious. In a book by author Carolyn See called The Handyman, a handyman is really an aspiring but discouraged artist who transforms the lives of people he works for, as well as having sexual encounters with some of his clients, and his experiences improve his artistic output.[24] The book suggests handymen discover "the appalling loneliness of the women who call him for help" whose needs are sometimes "comic," sometimes "heartbreaking," and deep down "sexual".[25] A 1980 movie called The Handyman was about a carpenter-plumber who was "good at what he does" but is "too honest and trusting," and gets taken advantage of by "women who find him handsome and understanding;" the movie earned negative reviews from critic Vincent Canby.[26] Other movies have used a rather tired formula of sexy-handyman meets bored-housewives, such as The Ups and Downs of a Handyman, a 1975 movie in which "Handsome Bob also finds he's a fast favorite with the local housewives, who seem to have more than small repairs on their minds."[27] In Canada, there's a television show called Canada's Worst Handyman which is a reality show in which handyman contestants try their best on jobs in order to not be labeled worst handyman. Home Improvement is an American television sitcom starring Tim Allen, which aired 1991 to 1999. On the children's television show Mister Rogers' Neighborhood, Handyman Negri was one of the characters residing in The Neighborhood of Make-Believe, as well as the neighborhood Mister Rogers resides in. Handy Manny is an American/Hispanic preschool television show that airs on Disney Junior and stars a handy man cartoon character named Manny. The Belgian comics and media franchise The Smurfs depicts Handy Smurf with traditional handyman's accoutrements, such as overalls, carpenter's pencil and work hat. Happy Tree Friends also has an orange beaver named Handy who is a handyman.
How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.
×