Risk: If your house was built 
before 1994 and still has the original plumbing fixtures, you’re using 
30 to 40 percent more water than 
a comparable new home. Because about 70 percent of the water flowing through the showerhead is hot, 
that means higher heating bills too. A basic showerhead can cost just $15 and could pay for itself in reduced water and heating costs after just one month. Calculate your 
savings at epa.gov/watersense/watersense-calculator.
If you find that drawer slides are bent, rollers are broken or rollers won’t turn even after lubricating, replacement is the best solution. To keep the project simple, buy new slides that are identical (or almost identical) to the old ones. That way, replacement is an easy matter of unscrewing the old and screwing on the new. Remove a drawer track and a cabinet track and take them shopping with you. Learn how to build an under-cabinet drawer here.
When the kitchen faucet leaks, you can’t just call the super. Instead, you have to find a handyman willing to do the work — unless you want to figure out how fix it yourself. But that would mean spending half a day at Home Depot wandering around the plumbing aisle. Buy the wrong materials and you may be back at the store a week later, or calling that handyman anyway to fix your mistake.

Grandma’s Handyman Service provides homeowners and businesses with superior handyman services at affordable prices. Our happy customers give us lots of repeat business and lots of nice compliments. But don’t take our word for it! Click here to read what our happy handyman customers have to say. And then call us today for minor or major repairs, small remodeling projects or just to finally get that honey-do list completed!

Though it can seem intimidating, installing your own batting installation can be easy, and take just a few hours if you isolate the need to a few key spaces. Have a drafty attic? Start there. Concerned about a freezing crawl space? Throw on your work jeans and get to work. These insulating spaces will instantly feel warmer and you’ll notice the savings on your next heating bill. Read how to install insulation here.
While you’re at it: Any appliance that uses water has a shutoff valve. But when valves go untouched for years, mineral deposits can make them impossible to close. Before that happens, locate the valves for your washer, ice maker, water heater, etc., and turn the handle (clockwise, about a quarter turn) every year or so (more often if your water is very hard), and then turn it back. Here are some ten-minute maintenance tasks you didn’t know you needed.
Silicone dries quickly and invisibly and doesn’t attract dirt, making it a good lubricant for drawer rollers, window tracks, door locks, bike parts, and other plastic, metal and rubber surfaces. It also helps protect metal against rust. Lithium grease is a long-lasting, weather-resistant (though somewhat messy) lubricant for garage door tracks, car doors and latches, and other metal parts that get heavy use outside. Check out 20 brilliant ways to use WD-40, another must-have lubricant for home repairs.

When you hire handyman services, you need to be sure that the team is going to turn up on time. Nothing is more frustrating than being given an 8 hour arrival window, forcing you to take a day off of work to sit around and wait. And nothing is more frustrating than a last minute cancellation.  When you book handyman services through Handy, you can be sure that they'll arrive at the time you request. We’ll connect you with the right people for the job so you can worry about the things that really need your attention—not fixing that light fixture.


We pride ourselves on offering some of the most versatile home repair services in the area. Our crews are skilled enough to fix or improve almost anything in your house, outside and inside. Considering our services include roofs and gutters, floors and walls, and woodwork too, we can honestly say that we fix up your house from top to bottom. Each aspect is completely customized to your tastes, because we want you to enjoy every single part of your living space.
Silicone dries quickly and invisibly and doesn’t attract dirt, making it a good lubricant for drawer rollers, window tracks, door locks, bike parts, and other plastic, metal and rubber surfaces. It also helps protect metal against rust. Lithium grease is a long-lasting, weather-resistant (though somewhat messy) lubricant for garage door tracks, car doors and latches, and other metal parts that get heavy use outside. Check out 20 brilliant ways to use WD-40, another must-have lubricant for home repairs.
eople Working Cooperatively, a Cincinnati-based nonprofit that serves the Greater Cincinnati area, has teamed up with the City of Cincinnati to offer the Cincinnati Lead Education and Remediation Program (CLEAR). PWC was selected by the City of Cincinnati to provide all intake applications for homeowners interested in the CLEAR program.This new program reduces lead hazards from your home and could involve repairs such as a window replacement or covering lead surfaces.You may qualify if all of the following apply to your household:A child under six resides in your home or spends at least six hours per week in your home on a regular basis You have owned and lived in your home for more than one yearYour home was built before 1978You live in one of these city neighborhoods:Bond Hill, Westend, Over-The-Rhine, Mt. Auburn, CUF, Corryville, Madisonville, Avondale, South Cumminsville, North and South Fairmount, West, East and Lower Price Hill, Walnut Hills, Evanston Northside or CarthageTo apply for the service or see if you qualify call 513-366-4699!
Intimidated by this seemingly daunting project? Don’t be. If you have the will and a whole day (or two) to yourself, you can refinish the hardwood floors in the major areas of your home. You don’t necessarily need to sand, but if the floor is damaged enough to warrant buffing, check out your local hardware store and rent the equipment for anywhere from 4-48 hours. Here’s how to refinish your hardwood floors.
You may qualify if all of the following apply to your household:A child under six resides in your home or spends at least six hours per week in your home on a regular basis You have owned and lived in your home for more than one yearYour home was built before 1978You live in one of these city neighborhoods:Bond Hill, Westend, Over-The-Rhine, Mt. Auburn, CUF, Corryville, Madisonville, Avondale, South Cumminsville, North and South Fairmount, West, East and Lower Price Hill, Walnut Hills, Evanston Northside or Carthage
In theory, the cost of building-wide improvements should be less in a condo because it is spread out across dozens of residents, and the sheer scale of the project could lower the overall price. But it does not always work out that way. Condo board members are volunteers who may not be skilled negotiators or knowledgeable about construction. They may take the first bid they get, or agree to more work than is necessary. If complications increase the cost of the job, residents won’t necessarily know. “This is one of the potential downsides of a condo or co-op scheme,” said Eric D. Sherman, a real estate lawyer and partner in the New York office of Pryor Cashman. “Lots of the time, boards are under the gun. They’re not paid for their efforts, they take the first bid from the first contractor that they see and they say, ‘sign me up.’”
Sussex County Habitat for Humanity offers a Home Repair Program that performs repair services to help low-income homeowners impacted by age, disability and family circumstances reclaim their homes with pride and dignity. Volunteer teams work to improve the condition of homes by painting, landscaping, and performing minor repairs at minimal costs to homeowners who would otherwise be unable to complete home repairs on their own.  In addition, SCHFH now offers home repair and renovation services on a larger scale that aim to alleviate critical health, life and safely issues.  Able-bodied homeowners are asked to work alongside the volunteers in a cooperative effort.
Instead of forking over $5,000-10,000 to replace all of your old windows with brand new ones, consider repairing old windows yourself. With a few hundred dollars in supplies (sand paper, paint, window glaze, etc.), you’ll be prepared to reglaze every window in your house. Though it can be a tad time consuming, you can prioritize the project by room, removing windows one by one to paint, reglaze, and, if necessary, replace any cracked glass. Get started glazing your windows here.
Tiny holes in shingles are sneaky because they can cause rot, a leaky roof and other damage for years before you notice the obvious signs of a leak. You might find holes left over from a satellite dish or antenna mounting brackets or just about anything. And exposed, misplaced roofing repair nails should be pulled and the holes patched. Small holes are simple to fix, but the fix isn’t to inject caulk in the hole. You’ll fix this leaky roof problem with flashing.
It is not uncommon for power switches and breakers to be accidentally turned off when other appliances are being installed. Homeowners are encouraged to check their circuit breaker to make sure the issue isn’t as simple as needing to turn a switch back on. A circuit breaker is typically located in the garage, although in some homes, the circuit breaker can be found in the basement, hallway or storage room.
At age 16, Jerry Torre became the unlikely handyman and close friend to the recluse aunt of Jackie Kennedy Onassis and her daughter who at the time were living in a crumbling East Hampton, N.Y., estate. — Stephanie Nolasco, Fox News, "Jackie Kennedy Onassis was 'horrified' of recluse aunt, cousin living in crumbling Grey Gardens, book claims," 12 Sep. 2018 Pascal is a poacher, a handyman and, for Moll, a madly attractive potential lover. — Justin Chang, latimes.com, "Jessie Buckley flirts with danger in the tense, uneven British thriller 'Beast'," 10 May 2018 Two handymen found the victim and called 911 around 7:15 p.m. the same day. — Heidi Groover, The Seattle Times, "Tacoma couple arrested in connection with death of 67-year-old Renton man," 26 Sep. 2018 The same goes for handymen, painters, anyone in trade. — Carren Jao, latimes.com, "Getting through that condo remodel means taking extra steps," 8 June 2018 The handyman’s hut offers subscribers access to hedge trimmers, chain saws, leaf blowers and other equipment; users pay a flat monthly fee to borrow the tools and return them when they’re done. — Philip Delves Broughton, WSJ, "‘Subscribed’ Review: For a Flat Monthly Fee," 17 July 2018 Each member of the family had specific roles; his were trucker and handyman. — Annie Martin, OrlandoSentinel.com, "UCF's Dale Whittaker says he will rise to challenge of presidency," 31 Mar. 2018 Luthy was getting a few handyman jobs here and there, but wanted to see if Lowe's would hire him. — Megan Friedman, Country Living, "A Lowe's Store in Texas Hired a Disabled Veteran – And His Service Dog," 6 Dec. 2016 This 18-in-one tool allows the handyman on your list to carry his toolbox in his wallet. — Brianna Steinhilber /, NBC News, "18 last-minute Father's Day gifts for every type of dad (and every budget)," 12 June 2018
Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.
JW were very prompt to reply to our initial quote request in which we described using the master shower caused water to pour down the HVAC return duct and was collecting within the walls and causing water damage on the first floor and in the basement ceiling. We also reached out to see if they could resolve a water issue in a corner of the basement that had become oversaturated during the heavy DC rains this summer causing heavy mold within the insulation and a few rotted studs (in addition to moldy drywall). Josh quickly scheduled a time to come out and take a look at the situation and provided great upfront information regarding what he thought the issue might be (initially believed a ripped rubber liner in the shower), price estimate, and description of the teams they use to work on projects. He estimated 2 workers over 3-4 days for $5,952.00 to $7,936.00 dependent on the severity of the issue and materials required. Once we scheduled the work, Cesar was out on time (a little early every day) from Monday through midday Wednesday. On site Cesar let me know the issue actually seemed to be bad grouting and caulking from the original house flippers. He offered to re-grout the entire shower and re-caulk, then test the shower instead of tearing up the stone tile on the floor. The next day we tested the shower for 10-15 minutes and no leak! Luckily for us the issue was smaller than expected which saved us a lot of hassle and money and I'm glad he opted to try that before blindly tearing up the shower. Beyond the high quality of work in general, a few things stood out in my mind as to how customer-oriented JW is: 1) Cesar constantly checked in if he wanted our opinion on things before moving forward. 2) Within the main leak area, he sprayed anti-fungal solution to prevent residual build up. 3) In the basement leak area, they sprayed base-level drylock to help prevent further issues. 4) We had plans to paint the areas they worked on so we didn't require they to repaint but it was offered to us. When they learned we planned on painting, they primed the area so it was ready for us when we got to painting it. 5) The cleanup crew collected all leftover materials and some extra left by the original flippers. Overall the project came in under budget and under timeline. We were exceptionally pleased with JW and will continue to use them as we need services like theirs.

This is a fun one. Composite wood paneling may have been all the rage in the 60s and 70s, but unless it’s still in perfect condition and painted white, it’s probably an eyesore. Popping off this decorative paneling can take minutes, and is seriously satisfying. Just be ready: you never know what condition the wall is in underneath. Be prepared to do a little plaster repair and, of course, repaint. Click here to learn how to prepare a wall for painting.
Inspect and replace your engine air filter. Just unscrew or unclip the air filter box retainers and remove the old filter. Then hold a shop light behind the filter to see how much light passes through. If the filter blocks 50 percent of more of the light, replace the filter. If not, put it back in, secure the air filter box cover and keep driving. Get the full step-by-step on changing your air filter here. It’s one of the easier things you can do to fix up cars.
A 2018 HomeAdvisor survey found that homeowners underestimated the cost of fixing or updating just about everything in their homes. When it came to interior painting, for example, survey participants estimated the work would cost $734. But the national average is $1,744. One of the few items they overestimated was a new toilet — the average is $370, not $405. 
×