Perhaps the most perplexing repairs facing a home-owner are broken or damaged things. In today's era of built-in obsolescence for many products, it is often more convenient to replace something rather than attempt to repair it. A repairman is faced with the tasks of accurately identifying the problem, then finding the materials, supplies, tools and skills necessary to sufficiently effect the repair. Some things, such as broken windows, appliances or furniture can be carried to a repair shop, but there are many repairs that can be performed easily enough, such as patching holes in plaster and drywall, cleaning stains, repairing cracked windows and their screens, or replacing a broken electrical switch or outlet. Other repairs may have some urgency, such as a broken water pipes, broken doors, latches or windows, or a leaky roof or water tank, and this factor can certainly justify calling for professional help. A home handyman may become adept at dealing with such immediate repairs, to avoid further damage or loss, until a professional can be summoned.

Sooner or later, every sprayed ceiling is going to get a water stain or a scrape. Spray texture in a can won’t perfectly match every ceiling texture, but it’s usually close, and a lot easier than respraying a whole ceiling. Before spraying, seal the patch with a stain-blocking primer, cover the floor and furniture, and practice your technique on scrap plywood or cardboard. Buy ceiling texture on Amazon now.
José was quick to respond to my request for an estimate to install a new back door. He came over and sized it up, sent me a fair priced quote the next day, and was back with workers soon after I accepted the quote and immediately started working. I'm extremely satisfied with the work that was performed--and the door needed to be framed and set inside the metal frames for the house, which is a little more complex than a regular door installation. I will definitely hire Jose and Jireh Contractor again!

Check for cracked housings on plastic roof vents and broken seams on metal ones. You might be tempted to throw caulk at the problem, but that solution won’t last long. There’s really no fix other than replacing the damaged vents. Also look for pulled or missing nails at the base’s bottom edge. Replace them with rubber-washered screws. In most cases, you can remove nails under the shingles on both sides of the vent to pull it free. There will be nails across the top of the vent too. Usually you can also work those loose without removing shingles. Screw the bottom in place with rubber-washered screws. Squeeze out a bead of caulk beneath the shingles on both sides of the vent to hold the shingles down and to add a water barrier. That’s much easier than renailing the shingles.


This summer, they decided to paint the frames black, which cost $900. Mr. Sievers, a special-education teacher, and his wife, a doctor, could have done the work themselves, a solution that do-it-yourself enthusiasts would suggest. But the doors face the street, and the couple wanted the end result to look polished. “My dad and my uncle used to always do home repairs and everything used to come out uneven or crooked,” Mr. Sievers said. So he paid a professional.
There’s nothing worse than starting a sink or toilet repair only to find that the shutoff valve won’t shut off. Some shutoff valves are easy to replace. For those that aren’t, turn off the main water valve, remove the packing nut, and then unscrew the stem and take it to the hardware store to find a replacement washer. Clean any grit out of the valve body and pop on the new washer. The valve will work like new.

Here’s a quick fix for a drawer front that’s pulling off. Cut a couple of lengths of quarter-round the same height as the drawer sides. Hold them in place while you drill a couple of holes through the sides and front of the drawer box. Dab some polyurethane glue (wood glue doesn’t stick well to finished surfaces) on the pieces of quarter-round before screwing them into place. Here’s how to fix sticky wooden drawers.
How to DIY it: Turn it off by opening the disconnect box (typically located on the outside wall near the unit) and pulling out the disconnect block inside (above). Now take a good look at the unit. If the vents are caked with fuzz from dandelions or cottonwood trees, vacuum the vents. Then rinse the unit with a hose using moderate pressure (the flimsy fins might bend under strong pressure). As you spray, peer down into the unit. You should see water streaming through. If not, the fins are still clogged, so keep rinsing.
An estimate was that in 2003, the market for home-maintenance and repair spending was up 14% from 2001 to 2003.[12] Another estimate was that the market in the United States was $126 billion and was increasing by about 4% annually.[10] American homes are aging; one estimate was that in 2007, more than half of all homes are older than 25 years.[12] And, as populations worldwide tend to become older, on average, and since increasingly elderly people will be less inclined and able to maintain their homes, it is likely that demand for handyman services will grow.[original research?][citation needed] 

Everyone has a different skill set, and not everyone was put on this planet with the same aptitude for manual labor. And that’s okay! Whatever your needs, the Handy platform can connect you with the right professionals who won’t be daunted by your task, whatever it might be. Whether you need help with a door that won’t close, a squeaky hinge, drywall repair, or fixing a broken table leg, we’ve got you covered.  You can’t go wrong with Handy—let us connect you with a top-rated handyman with the right skills for your job.
×