Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.
Our Repair Programs focus on a variety of tasks that keep the homeowner safe in their own home.   When possible, volunteer labor is offered at no cost to homeowners. Materials and services are paid for by the homeowner through a not-for-profit loan agreement. The scope of work is defined by SCHFH and agreed on by both parties before the work begins. 

There's no national standard or regulation for handymen. Licensing and regulation vary by state. New Jersey, for example, requires handymen who work for a profit to register with the state and carry insurance. California requires handymen to carry a license from the State Contractors License Board to work on any project that exceeds $500 in labor and material costs. Find out before you hire the handyman if he or she has the skills needed to complete your project.
If you have shallow scratches or nicks, hide them with a stain-filled touch-up marker. Dab on the stain and wipe off the excess with a rag. But beware: Scratches can absorb lots of stain and turn darker than the surrounding finish. So start with a marker that’s lighter than your cabinet finish and then switch to a darker shade if needed. For deeper scratches, use a filler pencil, which fills and colors the scratch. Or, try using a walnut to remove scratches in wood!

Comment: I need to have two smoke detectors installed, One is in the master bedroom (vaulted ceiling) and one in the basement. I need 4 lights installed in the kitchen (vaulted ceiling). I need the battery replaced in the smoke detector in the living room (vaulted ceiling). Lastly, I would like the light bulbs replaced in 4 ceiling fans. They are in the florida room, living room (vaulted ceiling), master bedroom (vaulted ceiling), and second bedroom.

This was our second use of the JW Home Improvement. The first time experience was wonderful. They were professional, did the job within agreed time and price, so we hired them again. This second experience was the polar opposite. We were seeking handyman services, but the estimator from JW turned each item on the list into a major job. We ended up with a coupon that we'd paid for, but no handyman services delivered, and no follow up call from the company to discuss. We ultimately hired another handyman who did a beautiful job within budget.


When you hire a contractor or specialist, they usually supply the materials, and often at a markup. If they don't provide the materials, they may not guarantee a repair, or your choices are limited to what they have in stock. When you choose your own materials, you know how much the product costs, and you can stay within your budget. You also get to choose the manufacturer, finish and register any warranty agreement.
Sooner or later, every sprayed ceiling is going to get a water stain or a scrape. Spray texture in a can won’t perfectly match every ceiling texture, but it’s usually close, and a lot easier than respraying a whole ceiling. Before spraying, seal the patch with a stain-blocking primer, cover the floor and furniture, and practice your technique on scrap plywood or cardboard. Buy ceiling texture on Amazon now. 

It is instinctual for homeowners to contact an HVAC tech when they notice irregularities in their cooling or heating system. These irregularities could be a direct result of a dirty or clogged air filter. We encourage homeowners to check their filters and replace if necessary. It’s also beneficial for homeowners with pets, carpet, or for homes near fields or construction zones to have multiple filters for convenient replacement.
You'll get an email from your pro to confirm the date, time, and other details. Please be prepared to provide your pro the exact list of projects you would like them to complete and, wherever possible, related product URLs. During appointment scheduling, you will have the option to allow the provider to contact you to discuss the projects and tools needed in more detail.
How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening 
the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with 
a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle 
anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill 
or a screwdriver, and then re­attach everything.
How to DIY it: Gently tug the loose part of the carpet to find the point where it’s still attached. Snip 
it off as close to the backing as possible and save it. Use painter’s tape to surround the repair area. Squeeze 
a heavy bead of carpet seam sealer (about $6 at home centers) into the run. Then fill in the hole with the saved fiber, using a screwdriver to press it into the sealer bit by bit until the area looks like the surrounding 
carpet (below).
Need your garage door repaired? Odds are, once you account for materials, labor and unforeseen hiccups, you’ll be writing a check for a grand. Your sump pump died? A new one could cost you around $600 for parts and labor, which doesn’t seem so bad considering the alternative is a flooded basement. But then the plumber might discover that the pipe carrying the water from the house to the street is clogged with years’ of debris and needs to be flushed out. And maybe there’s a blockage somewhere. There you have it: $1,000.
If you can’t see any telltale flow marks, and since the stain is fairly small, look at the underside of the roof for ‘shiners.’ A shiner is a nail that missed the framing member, in this case when the carpenter nailed the roof sheathing to the rafters. Moisture that escapes into the cold attic from the rooms below often condenses on cold nails. Sometimes you can spot this if you climb up into your attic on a cold night. The nails will look white because they’re frosted. When the attic heats up a bit during the day, the frost melts and drips, then the nails frost up at night again and so on. The solution is to simply clip the nail with a side-cutting pliers.
Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.
At Home Handyman Services provides a variety of services such as maintenance, safety and convenience modifications for people who choose to remain independent in their own homes. Our goal is to assist seniors and their families with maintaining a safe and comfortable living environment. Our carefully screened service providers can help with the following:
Home repair involves the diagnosis and resolution of problems in a home, and is related to home maintenance to avoid such problems. Many types of repairs are "do it yourself" (DIY) projects, while others may be so complicated, time-consuming or risky as to suggest the assistance of a qualified handyman, property manager, contractor/builder, or other professionals. Repair is not necessarily the same as home improvement, although many improvements can result from repairs or maintenance. Often the costs of larger repairs will justify the alternative of investment in full-scale improvements. It may make just as much sense to upgrade a home system (with an improved one) as to repair it or incur ever-more-frequent and expensive maintenance for an inefficient, obsolete or dying system. For a DIY project, it is also useful to establish limits on how much time and money you're willing to invest before deciding a repair (or list of repairs) is overwhelming and discouraging, and less likely to ever be completed.

How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.

×