Live in a condo or co-op in the city, and your monthly maintenance fee may be large enough to make you envy the owner of a single-family home. But that regular common charge means that you get to live in ignorant bliss about what it costs to keep a property functioning. You may never know when the gutters get cleaned, who gets hired to do the work or even how much the job costs. None of the details are your problem because the work just gets done whether you’re paying attention or not.
Here’s a quick fix for a drawer front that’s pulling off. Cut a couple of lengths of quarter-round the same height as the drawer sides. Hold them in place while you drill a couple of holes through the sides and front of the drawer box. Dab some polyurethane glue (wood glue doesn’t stick well to finished surfaces) on the pieces of quarter-round before screwing them into place. Here’s how to fix sticky wooden drawers.

Tired of listening to those cabinet doors bang shut? Peel-and-stick door and drawer bumpers are the solution. Get a pack of 20 at a home center for a few dollars. Make sure the back of the door is clean so the bumpers will stick, then place one at the top corner and another at the bottom. Plus: Keep your kitchen (and whole house!) clean with these 100 brilliant cleaning hacks.
You'll get an email from your pro to confirm the date, time, and other details. Please be prepared to provide your pro the exact list of projects you would like them to complete and, wherever possible, related product URLs. During appointment scheduling, you will have the option to allow the provider to contact you to discuss the projects and tools needed in more detail.
Risk: The range hood sucks cooking fumes up and out of the kitchen. As grease splatters, it builds up and clogs the filter in the underside of the hood, keeping the fan from working as it should. This could cause your smoke alarm to go off, attract fruit flies, and leave potentially harmful pollutants from your gas or electric range lingering in the air. And if you have to replace the motor, it will cost around $200.
How to DIY it: A simple cleaning often solves the problem. Start by pulling out the lower dish rack. 
Remove the spray arm and use a thin piece of wire to clean out the holes where water sprays through. Scoop or vacuum out any leftover food 
particles from the filter area, then 
remove the filter screen (above), if possible, and give it a good rinse.
JW were very prompt to reply to our initial quote request in which we described using the master shower caused water to pour down the HVAC return duct and was collecting within the walls and causing water damage on the first floor and in the basement ceiling. We also reached out to see if they could resolve a water issue in a corner of the basement that had become oversaturated during the heavy DC rains this summer causing heavy mold within the insulation and a few rotted studs (in addition to moldy drywall). Josh quickly scheduled a time to come out and take a look at the situation and provided great upfront information regarding what he thought the issue might be (initially believed a ripped rubber liner in the shower), price estimate, and description of the teams they use to work on projects. He estimated 2 workers over 3-4 days for $5,952.00 to $7,936.00 dependent on the severity of the issue and materials required. Once we scheduled the work, Cesar was out on time (a little early every day) from Monday through midday Wednesday. On site Cesar let me know the issue actually seemed to be bad grouting and caulking from the original house flippers. He offered to re-grout the entire shower and re-caulk, then test the shower instead of tearing up the stone tile on the floor. The next day we tested the shower for 10-15 minutes and no leak! Luckily for us the issue was smaller than expected which saved us a lot of hassle and money and I'm glad he opted to try that before blindly tearing up the shower. Beyond the high quality of work in general, a few things stood out in my mind as to how customer-oriented JW is: 1) Cesar constantly checked in if he wanted our opinion on things before moving forward. 2) Within the main leak area, he sprayed anti-fungal solution to prevent residual build up. 3) In the basement leak area, they sprayed base-level drylock to help prevent further issues. 4) We had plans to paint the areas they worked on so we didn't require they to repaint but it was offered to us. When they learned we planned on painting, they primed the area so it was ready for us when we got to painting it. 5) The cleanup crew collected all leftover materials and some extra left by the original flippers. Overall the project came in under budget and under timeline. We were exceptionally pleased with JW and will continue to use them as we need services like theirs.
Sooner or later, every sprayed ceiling is going to get a water stain or a scrape. Spray texture in a can won’t perfectly match every ceiling texture, but it’s usually close, and a lot easier than respraying a whole ceiling. Before spraying, seal the patch with a stain-blocking primer, cover the floor and furniture, and practice your technique on scrap plywood or cardboard. Buy ceiling texture on Amazon now.

Even tasks that seem relatively small can add up. Consider the French doors that David Sievers, 53, and his wife, Ulin Sargeant, 47, installed two years ago to replace sliding glass doors on their two-bedroom house in Monrovia, Calif. The doors cost $2,000. But then they paid $1,700 for installation, $500 for a painter to restore the stucco and paint, and $1,600 for an engineering plan required by the city.
While you’re at it: Don’t cheap out and use rock salt instead of water-­softener salt, even though rock salt costs half as much. It contains far more impurities that will clog up the works, and you could wind up needing to spend $600 or more for a new water softener. Make sure you always follow these home care tips to save you time, money, and stress.
When vinyl windows and doors don’t operate smoothly, it’s usually because gunk has built up in the channels. But sometimes even clean windows and doors can bind. Try spraying dry PTFE spray lubricant on the contact points and wiping it off with a rag. Don’t use oil lubricants; they can attract dirt, and some can damage the vinyl. Make sure to keep your windows clean all year long with these pro tips.

You may qualify if all of the following apply to your household:A child under six resides in your home or spends at least six hours per week in your home on a regular basis You have owned and lived in your home for more than one yearYour home was built before 1978You live in one of these city neighborhoods:Bond Hill, Westend, Over-The-Rhine, Mt. Auburn, CUF, Corryville, Madisonville, Avondale, South Cumminsville, North and South Fairmount, West, East and Lower Price Hill, Walnut Hills, Evanston Northside or Carthage
In addition to the major tasks like painting, renovations, and replacements, we also do little jobs. Some of these include doorknob repair, bookshelves and built-ins, and hanging pictures and curtains. Other companies won’t perform this work, but we’re happy to do it all for you at a price you can afford. Our services are so inclusive that we’ll be the only ones you need to call whenever something goes amiss in your house.
The average single-family homeowner spends around $2,000 a year on maintenance, according to Bankrate.com. That is considerably less than the monthly fees for most condos or co-ops. But even though the monthly outlay for those homeowners might be lower than that of condo or co-op owners, house owners generally are not squirreling away those savings for a rainy day. Nearly half of them have less than $1,000 saved, and a third have nothing saved, according to Liberty Mutual Insurance. So when that sump pump suddenly fails, odds are, we’re scrambling to pay the plumber for a new one.
How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts. 
×