Many people can do common household repairs. There are resources on the Internet, as well as do-it-yourself guide books, with instructions about how to complete a wide range of projects. Sometimes the fix-it skill is seen as genetic, and people lacking such skills are said to "lack the handy-man gene". One trend is that fewer homeowners are inclined to do fix-up jobs, perhaps because of time constraints, perhaps because of lack of interest; one reporter commented "my family's fix-it gene petered out before it reached my generation."
How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill or a screwdriver, and then reattach everything.
Need your garage door repaired? Odds are, once you account for materials, labor and unforeseen hiccups, you’ll be writing a check for a grand. Your sump pump died? A new one could cost you around $600 for parts and labor, which doesn’t seem so bad considering the alternative is a flooded basement. But then the plumber might discover that the pipe carrying the water from the house to the street is clogged with years’ of debris and needs to be flushed out. And maybe there’s a blockage somewhere. There you have it: $1,000.
You’ve got an ever increasing to-do list of home improvements like changing out a bathroom faucet, replacing missing shingles on the roof and painting a kitchen wall. You could hire a plumber, roofer and painter who have conflicting schedules and their own service charges, or you could hire a handyman to complete all three projects in one day for one hourly rate.
An estimate was that in 2003, the market for home-maintenance and repair spending was up 14% from 2001 to 2003. Another estimate was that the market in the United States was $126 billion and was increasing by about 4% annually. American homes are aging; one estimate was that in 2007, more than half of all homes are older than 25 years. And, as populations worldwide tend to become older, on average, and since increasingly elderly people will be less inclined and able to maintain their homes, it is likely that demand for handyman services will grow.[original research?]
While you’re at it: If you don’t have a programmable thermostat, consider getting one. According to the U.S. Department of Energy, an Energy Star–rated model can save you about $180 in heating and cooling costs each year. You can buy one for about $40 and install it yourself. It’s a relatively easy job; no rewiring required. On the other hand, these are home improvement projects you should never, ever DIY.
Home repair is a delicate job that is always best left in the hands of people who know it well. An inexperienced or unlicensed contractor can end up making problems worse instead of better and costing you more money. At our company, we only hire licensed experts with years of experience to their names. Whether you need quick drywall repair or full restorations, you can count on us to do it correctly the first time. Proper repair or installation now can save you bundles of both money and headaches in the future.
Dab any type of kitchen cooking oil (olive, canola or sunflower) onto a paper towel. Then lay the paper towel over the residue that refuses to budge. Wait a few minutes while the oil works to dissolve the stubborn glue. Finally, remove the towel and rub away the sticker residue with another clean paper towel. However, you need to be cautious with stains on more absorbent materials.
How to DIY it: Turn it off by opening the disconnect box (typically located on the outside wall near the unit) and pulling out the disconnect block inside (above). Now take a good look at the unit. If the vents are caked with fuzz from dandelions or cottonwood trees, vacuum the vents. Then rinse the unit with a hose using moderate pressure (the flimsy fins might bend under strong pressure). As you spray, peer down into the unit. You should see water streaming through. If not, the fins are still clogged, so keep rinsing.
José was quick to respond to my request for an estimate to install a new back door. He came over and sized it up, sent me a fair priced quote the next day, and was back with workers soon after I accepted the quote and immediately started working. I'm extremely satisfied with the work that was performed--and the door needed to be framed and set inside the metal frames for the house, which is a little more complex than a regular door installation. I will definitely hire Jose and Jireh Contractor again!
So a door knob slammed through the wall after one too many times slamming the door. No need to call your handy contractor. You can easily fix a few holes in your drywall by injecting a setting compound (for smaller holes) or by cutting out the damaged sections and replacing them with new drywall (for larger ones). Check out this handy tutorial for more on repairing holes.
If you can say the same, that’s great! But be sure to take steps to replenish the funds quickly. Unfortunately, repairs can come at any time—even one right after another. So you’ll want to be ready. If you are thinking about doing other renovations in addition to your emergency repairs, use SoFi’s Home Project Value Estimator to find out the resale value of your project.
How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about $7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.