How to DIY it: Clean up any rough edges around the hole, then stick the patch onto the wall over the hole (left). Using the taping knife, spread a layer of joint compound over it and let it dry overnight. Then spread a wider second coat, feathering out the compound on all sides to make the patch blend in. Let it dry, then apply one more coat extending 8 to 12 inches beyond the patch in 
all directions. After the final coat dries, sand the area with a sanding sponge (a foam block wrapped in sand­paper) until it feels smooth and even. Prime, and then paint.

In theory, the cost of building-wide improvements should be less in a condo because it is spread out across dozens of residents, and the sheer scale of the project could lower the overall price. But it does not always work out that way. Condo board members are volunteers who may not be skilled negotiators or knowledgeable about construction. They may take the first bid they get, or agree to more work than is necessary. If complications increase the cost of the job, residents won’t necessarily know. “This is one of the potential downsides of a condo or co-op scheme,” said Eric D. Sherman, a real estate lawyer and partner in the New York office of Pryor Cashman. “Lots of the time, boards are under the gun. They’re not paid for their efforts, they take the first bid from the first contractor that they see and they say, ‘sign me up.’”


While you’re at it: Don’t cheap out and use rock salt instead of water-­softener salt, even though rock salt costs half as much. It contains far more impurities that will clog up the works, and you could wind up needing to spend $600 or more for a new water softener. Make sure you always follow these home care tips to save you time, money, and stress.

Risk: If your house was built 
before 1994 and still has the original plumbing fixtures, you’re using 
30 to 40 percent more water than 
a comparable new home. Because about 70 percent of the water flowing through the showerhead is hot, 
that means higher heating bills too. A basic showerhead can cost just $15 and could pay for itself in reduced water and heating costs after just one month. Calculate your 
savings at epa.gov/watersense/watersense-calculator.


If you can’t see any telltale flow marks, and since the stain is fairly small, look at the underside of the roof for ‘shiners.’ A shiner is a nail that missed the framing member, in this case when the carpenter nailed the roof sheathing to the rafters. Moisture that escapes into the cold attic from the rooms below often condenses on cold nails. Sometimes you can spot this if you climb up into your attic on a cold night. The nails will look white because they’re frosted. When the attic heats up a bit during the day, the frost melts and drips, then the nails frost up at night again and so on. The solution is to simply clip the nail with a side-cutting pliers.

Sussex County Habitat for Humanity offers a Home Repair Program that performs repair services to help low-income homeowners impacted by age, disability and family circumstances reclaim their homes with pride and dignity. Volunteer teams work to improve the condition of homes by painting, landscaping, and performing minor repairs at minimal costs to homeowners who would otherwise be unable to complete home repairs on their own.  In addition, SCHFH now offers home repair and renovation services on a larger scale that aim to alleviate critical health, life and safely issues.  Able-bodied homeowners are asked to work alongside the volunteers in a cooperative effort.

How to DIY it: Coils are located 
on the back of the refrigerator or across the bottom. Pull the fridge away from the wall. (Hint: Grab the sides and pull from the bottom. You may want to lay cardboard on the floor first to prevent scratching.) Clean coils with a coil-cleaning brush (about $10 at home centers), then vacuum. Do this every six months or so.
When the kitchen faucet leaks, you can’t just call the super. Instead, you have to find a handyman willing to do the work — unless you want to figure out how fix it yourself. But that would mean spending half a day at Home Depot wandering around the plumbing aisle. Buy the wrong materials and you may be back at the store a week later, or calling that handyman anyway to fix your mistake.
Business Education Entertainment Government President Obama Visit 2009 General Election Health Live Healthy Non-Profit Sports Obituaries Pet Network Homeless Taskforce Weather Amherst Avon Avon Lake Elyria Grafton LaGrange Lorain North Ridgeville Oberlin Sheffield Lake Sheffield Village Vermilion Wellington LorainCounty.com Blog Digital Partners Advertise with Us
If you find that drawer slides are bent, rollers are broken or rollers won’t turn even after lubricating, replacement is the best solution. To keep the project simple, buy new slides that are identical (or almost identical) to the old ones. That way, replacement is an easy matter of unscrewing the old and screwing on the new. Remove a drawer track and a cabinet track and take them shopping with you. Learn how to build an under-cabinet drawer here.
Need your garage door repaired? Odds are, once you account for materials, labor and unforeseen hiccups, you’ll be writing a check for a grand. Your sump pump died? A new one could cost you around $600 for parts and labor, which doesn’t seem so bad considering the alternative is a flooded basement. But then the plumber might discover that the pipe carrying the water from the house to the street is clogged with years’ of debris and needs to be flushed out. And maybe there’s a blockage somewhere. There you have it: $1,000.
How to DIY it: There are lots of ways to clear a drain, so start with the easiest one. If your sink has a pop-up stopper, remove that and clean it. If that doesn’t do the trick, fill the sink with 3 or 4 inches of water and use a plunger to plunge the sink (plug the overflow hole with a wet rag first). Still slow? Try snaking the drain pipe with a metal hanger or a pipe-cleaning tool (sold at hardware stores for about $2).
From the beginning these guys were great. I received a text message asking me for all of the work I would like to be done. I initially only needed the service to mount my over the range microwave but because of his swift service, I was able to install floating shelves and a wine rack. There was communication all throughout the process and I loved how honest they were when they weren't 100% sure if they could do my microwave. Other than that, my son loved the handyman and walked around the apartment with our measuring tape telling me how may units things were. Loved the service and will definitely book again!
When the kitchen faucet leaks, you can’t just call the super. Instead, you have to find a handyman willing to do the work — unless you want to figure out how fix it yourself. But that would mean spending half a day at Home Depot wandering around the plumbing aisle. Buy the wrong materials and you may be back at the store a week later, or calling that handyman anyway to fix your mistake.
How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.
×