Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.

There's no national standard or regulation for handymen. Licensing and regulation vary by state. New Jersey, for example, requires handymen who work for a profit to register with the state and carry insurance. California requires handymen to carry a license from the State Contractors License Board to work on any project that exceeds $500 in labor and material costs. Find out before you hire the handyman if he or she has the skills needed to complete your project.
How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening 
the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with 
a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle 
anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill 
or a screwdriver, and then re­attach everything.

How to DIY it: Clean up any rough edges around the hole, then stick the patch onto the wall over the hole (left). Using the taping knife, spread a layer of joint compound over it and let it dry overnight. Then spread a wider second coat, feathering out the compound on all sides to make the patch blend in. Let it dry, then apply one more coat extending 8 to 12 inches beyond the patch in 
all directions. After the final coat dries, sand the area with a sanding sponge (a foam block wrapped in sand­paper) until it feels smooth and even. Prime, and then paint.


How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.
How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening 
the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with 
a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle 
anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill 
or a screwdriver, and then re­attach everything.
You can reschedule or cancel your service at any time. To reschedule, simply go to Your Orders, find your service order and click on the ‘Contact Provider’ button on Your Orders page. To cancel, click on the 'Cancel Order' button on Your Orders page. Payment goes to the pro from your secure Amazon account. Because you aren't charged until the actual work is completed, cancelling a job doesn't require a refund.
While you’re at it: Any appliance that uses water has a shutoff valve. But when valves go untouched for years, mineral deposits can make them impossible to close. Before that happens, locate the valves for your washer, ice maker, water heater, etc., and turn the handle (clockwise, about a quarter turn) every year or so (more often if your water is very hard), and then turn it back. Here are some ten-minute maintenance tasks you didn’t know you needed.

Franchise handyman firms sometimes pitch clients by asking prospective customers about their unresolved "to-do lists".[16] The firm does odd jobs, carpentry, and repairs.[16] Trends such as a "poverty of time" and a "glut of unhandy husbands" has spurred the business.[16] Technicians do a range of services including tile work, painting, and wallpapering.[17] "One firm" charges $88 per hour.[16] The firm targets a work category which full-fledged remodelers and contractors find unprofitable.[16] A consumer was quoted by a reporter explaining the decision to hire one firm: "'I couldn't find anyone to come in and help me because the jobs were too small', said Meg Beck of Huntington, who needed some painting and carpentry done. She turned to one franchise firm and said she liked the fact that the service has well-marked trucks and uniformed technicians and that a dispatcher called with the names of the crew before they showed up."[16] There are indications that these businesses are growing.[16] There are different firms operating.[12][18]


If you have a wallpaper seam that’s coming apart, reactivate the paste around the gap with a rag soaked in warm water. Hold the rag over the area for a minute or two, and then carefully open the gap a little larger so you’ll have more room for the sealer. Squeeze seam sealer (white glue works in a pinch) into the gap, and press the paper to the wall with a roller. Clean off the excess sealer with a sponge.
When you hire handyman services, you need to be sure that the team is going to turn up on time. Nothing is more frustrating than being given an 8 hour arrival window, forcing you to take a day off of work to sit around and wait. And nothing is more frustrating than a last minute cancellation.  When you book handyman services through Handy, you can be sure that they'll arrive at the time you request. We’ll connect you with the right people for the job so you can worry about the things that really need your attention—not fixing that light fixture.
Comment: I need to have two smoke detectors installed, One is in the master bedroom (vaulted ceiling) and one in the basement. I need 4 lights installed in the kitchen (vaulted ceiling). I need the battery replaced in the smoke detector in the living room (vaulted ceiling). Lastly, I would like the light bulbs replaced in 4 ceiling fans. They are in the florida room, living room (vaulted ceiling), master bedroom (vaulted ceiling), and second bedroom.
×