Sooner or later, every sprayed ceiling is going to get a water stain or a scrape. Spray texture in a can won’t perfectly match every ceiling texture, but it’s usually close, and a lot easier than respraying a whole ceiling. Before spraying, seal the patch with a stain-blocking primer, cover the floor and furniture, and practice your technique on scrap plywood or cardboard. Buy ceiling texture on Amazon now.
Dab any type of kitchen cooking oil (olive, canola or sunflower) onto a paper towel. Then lay the paper towel over the residue that refuses to budge. Wait a few minutes while the oil works to dissolve the stubborn glue. Finally, remove the towel and rub away the sticker residue with another clean paper towel. However, you need to be cautious with stains on more absorbent materials.
A variety of problems can befall your home’s doors, especially older doors that may start to sag, stick, develop drafts or experience other issues. Fixing or replacing a door is well within the capabilities of most homeowners, especially if you have a partner to help out. From installing new weather stripping to replacing the lock, you can handle it. Watch this video to see how simple it is to replace an interior door yourself.
In addition to the major tasks like painting, renovations, and replacements, we also do little jobs. Some of these include doorknob repair, bookshelves and built-ins, and hanging pictures and curtains. Other companies won’t perform this work, but we’re happy to do it all for you at a price you can afford. Our services are so inclusive that we’ll be the only ones you need to call whenever something goes amiss in your house.

How to DIY it: Gently tug the loose part of the carpet to find the point where it’s still attached. Snip 
it off as close to the backing as possible and save it. Use painter’s tape to surround the repair area. Squeeze 
a heavy bead of carpet seam sealer (about $6 at home centers) into the run. Then fill in the hole with the saved fiber, using a screwdriver to press it into the sealer bit by bit until the area looks like the surrounding 
carpet (below).
Tiny holes in shingles are sneaky because they can cause rot, a leaky roof and other damage for years before you notice the obvious signs of a leak. You might find holes left over from a satellite dish or antenna mounting brackets or just about anything. And exposed, misplaced roofing repair nails should be pulled and the holes patched. Small holes are simple to fix, but the fix isn’t to inject caulk in the hole. You’ll fix this leaky roof problem with flashing.
How to DIY it: Clean up any rough edges around the hole, then stick the patch onto the wall over the hole (left). Using the taping knife, spread a layer of joint compound over it and let it dry overnight. Then spread a wider second coat, feathering out the compound on all sides to make the patch blend in. Let it dry, then apply one more coat extending 8 to 12 inches beyond the patch in 
all directions. After the final coat dries, sand the area with a sanding sponge (a foam block wrapped in sand­paper) until it feels smooth and even. Prime, and then paint.
Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.

Periodic maintenance also falls under the general class of home repairs. These are inspections, adjustments, cleaning, or replacements that should be done regularly to ensure proper functioning of all the systems in a house, and to avoid costly emergencies. Examples include annual testing and adjustment of alarm systems, central heating or cooling systems (electrodes, thermocouples, and fuel filters), replacement of water treatment components or air-handling filters, purging of heating radiators and water tanks, defrosting a freezer, vacuum refrigerator coils, refilling dry floor-drain traps with water, cleaning out rain gutters, down spouts and drains, touching up worn house paint and weather seals, and cleaning accumulated creosote out of chimney flues, which may be best left to a chimney sweep.


Sooner or later, every sprayed ceiling is going to get a water stain or a scrape. Spray texture in a can won’t perfectly match every ceiling texture, but it’s usually close, and a lot easier than respraying a whole ceiling. Before spraying, seal the patch with a stain-blocking primer, cover the floor and furniture, and practice your technique on scrap plywood or cardboard. Buy ceiling texture on Amazon now.
×