How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.
Franchise handyman firms sometimes pitch clients by asking prospective customers about their unresolved "to-do lists".[16] The firm does odd jobs, carpentry, and repairs.[16] Trends such as a "poverty of time" and a "glut of unhandy husbands" has spurred the business.[16] Technicians do a range of services including tile work, painting, and wallpapering.[17] "One firm" charges $88 per hour.[16] The firm targets a work category which full-fledged remodelers and contractors find unprofitable.[16] A consumer was quoted by a reporter explaining the decision to hire one firm: "'I couldn't find anyone to come in and help me because the jobs were too small', said Meg Beck of Huntington, who needed some painting and carpentry done. She turned to one franchise firm and said she liked the fact that the service has well-marked trucks and uniformed technicians and that a dispatcher called with the names of the crew before they showed up."[16] There are indications that these businesses are growing.[16] There are different firms operating.[12][18]
Sooner or later, every sprayed ceiling is going to get a water stain or a scrape. Spray texture in a can won’t perfectly match every ceiling texture, but it’s usually close, and a lot easier than respraying a whole ceiling. Before spraying, seal the patch with a stain-blocking primer, cover the floor and furniture, and practice your technique on scrap plywood or cardboard. Buy ceiling texture on Amazon now.
Even tasks that seem relatively small can add up. Consider the French doors that David Sievers, 53, and his wife, Ulin Sargeant, 47, installed two years ago to replace sliding glass doors on their two-bedroom house in Monrovia, Calif. The doors cost $2,000. But then they paid $1,700 for installation, $500 for a painter to restore the stucco and paint, and $1,600 for an engineering plan required by the city.
A variety of problems can befall your home’s doors, especially older doors that may start to sag, stick, develop drafts or experience other issues. Fixing or replacing a door is well within the capabilities of most homeowners, especially if you have a partner to help out. From installing new weather stripping to replacing the lock, you can handle it. Watch this video to see how simple it is to replace an interior door yourself.

Upholstery shops charge almost $200 to fix tears in your seats. You can do it yourself in a few hours with a vinyl and leather repair kit (less than $20) from any auto parts store. You’ll have to practice a bit to get the right color mix and it might not be a perfect match when you’re done, but it’s a heck of a lot better than driving around with torn seats. Start by gluing reinforcing fabric onto the underside of the torn vinyl or leather. Then mix the heat-set filler to match your fabric color and apply it to the tear. Next, find a textured mat that most closely resembles the texture of your vinyl or leather and place it onto the liquid filler. Heat the patching tool with a clothes iron and press it onto the textured mat. Remove the patching tool, but leave the textured mat in place until the patch cools. Then peel it off. Get the full story on repairing leather here.

Franchise handyman firms sometimes pitch clients by asking prospective customers about their unresolved "to-do lists".[16] The firm does odd jobs, carpentry, and repairs.[16] Trends such as a "poverty of time" and a "glut of unhandy husbands" has spurred the business.[16] Technicians do a range of services including tile work, painting, and wallpapering.[17] "One firm" charges $88 per hour.[16] The firm targets a work category which full-fledged remodelers and contractors find unprofitable.[16] A consumer was quoted by a reporter explaining the decision to hire one firm: "'I couldn't find anyone to come in and help me because the jobs were too small', said Meg Beck of Huntington, who needed some painting and carpentry done. She turned to one franchise firm and said she liked the fact that the service has well-marked trucks and uniformed technicians and that a dispatcher called with the names of the crew before they showed up."[16] There are indications that these businesses are growing.[16] There are different firms operating.[12][18]
From the beginning these guys were great. I received a text message asking me for all of the work I would like to be done. I initially only needed the service to mount my over the range microwave but because of his swift service, I was able to install floating shelves and a wine rack. There was communication all throughout the process and I loved how honest they were when they weren't 100% sure if they could do my microwave. Other than that, my son loved the handyman and walked around the apartment with our measuring tape telling me how may units things were. Loved the service and will definitely book again!
Before you go through the trouble of repainting a ceiling to get rid of a water stain, try this trick. Spray the spot with a bleach and water solution (10 percent bleach), and wait a day or two. If it’s an old stain, use a mold and mildew remover from the grocery store. You’d be surprised how often the stain disappears by the next day. It works on both flat and textured ceilings.
Intimidated by this seemingly daunting project? Don’t be. If you have the will and a whole day (or two) to yourself, you can refinish the hardwood floors in the major areas of your home. You don’t necessarily need to sand, but if the floor is damaged enough to warrant buffing, check out your local hardware store and rent the equipment for anywhere from 4-48 hours. Here’s how to refinish your hardwood floors.

Most newer cabinets have self-closing hinges that hold the doors shut. Others have magnetic or roller catches. A catch that no longer keeps a door closed is either broken or out of adjustment. Catches are fastened with two screws, so replacing a damaged catch is simple. Adjustment is just as simple, but you might have to readjust the catch a couple of times before you get it right. Loosen the screws, move the catch in or out, and tighten the screws. If the door doesn’t close tightly, try again.

Depending on where you live, national averages can seem like a steal. Rene Artale’s four-bedroom house near Newcastle, in Westchester County, N.Y., suffered some damage during a storm last winter. A tree fell in the yard, damaging her fence, arbor and retaining wall. And heavy snow caused her roof to leak. The repair bills just kept piling up. Removing the tree, $3,800. Repairing the wall, $4,000. Fixing the roof, $3,800. Fixing the picket fence, $2,800. “It’s obscene,” Ms. Artale, 47, said.
Risk: The range hood sucks cooking fumes up and out of the kitchen. As grease splatters, it builds up and clogs the filter in the underside of the hood, keeping the fan from working as it should. This could cause your smoke alarm to go off, attract fruit flies, and leave potentially harmful pollutants from your gas or electric range lingering in the air. And if you have to replace the motor, it will cost around $200.
There’s nothing worse than starting a sink or toilet repair only to find that the shutoff valve won’t shut off. Some shutoff valves are easy to replace. For those that aren’t, turn off the main water valve, remove the packing nut, and then unscrew the stem and take it to the hardware store to find a replacement washer. Clean any grit out of the valve body and pop on the new washer. The valve will work like new.
You'll get an email from your pro to confirm the date, time, and other details. Please be prepared to provide your pro the exact list of projects you would like them to complete and, wherever possible, related product URLs. During appointment scheduling, you will have the option to allow the provider to contact you to discuss the projects and tools needed in more detail.
At Schloegel Design Remodel, we have over 38 years of experience as a home remodeling contractor. We specialize in providing professional Handyman and Property Solutions for numerous homeowners in the Kansas City area. Our highly skilled craftsmen are experts in what they do and are more than happy to help you cross things off your list to accomplish your household projects.
Often on the bottom of people's to-do list is home maintenance chores, such as landscaping, window and gutter cleaning, power washing the siding and hard-scape, etc. However, these maintenance chores pay for themselves over time. Often, injury could occur when operating heavy machinery or when climbing on ladders or roofs around your home, so if an individual is not in the proper physical condition to accomplish these chores, then they should consult a professional. Lack of maintenance will cost more due to higher costs associated with repairs or replacements to be made later. It requires discipline and learning aptitude to repair and maintain the home in good condition, but it is a satisfying experience to perform even seemingly minor repairs.
How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.
Plumbing vent boots can be all plastic, plastic and metal, or even two-piece metal units. Check plastic bases for cracks and metal bases for broken seams. Then examine the rubber boot surrounding the pipe. That can be rotted away or torn, allowing water to work its way into the house along the pipe. With any of these problems, you should buy a new vent boot to replace the old one. But if the nails at the base are missing or pulled free and the boot is in good shape, replace them with the rubber-washered screws used for metal roofing systems. You’ll find them at any home center with the rest of the screws. You’ll have to work neighboring shingles free on both sides. If you don’t have extra shingles, be careful when you remove shingles so they can be reused. Use a flat bar to separate the sealant between the layers. Then you’ll be able to drive the flat bar under the nail heads to pop out the nails.
×